[PATCH v6 8/8] ARM: sunxi: Add documentation for driver for SD/MMC hosts found on Allwinner sunxi SoCs
David Lanzendörfer
david.lanzendoerfer at o2s.ch
Sat Feb 15 18:34:00 EST 2014
Signed-off-by: David Lanzendörfer <david.lanzendoerfer at o2s.ch>
---
.../devicetree/bindings/mmc/sunxi-mmc.txt | 32 ++++++++++++++++++++
1 file changed, 32 insertions(+)
create mode 100644 Documentation/devicetree/bindings/mmc/sunxi-mmc.txt
diff --git a/Documentation/devicetree/bindings/mmc/sunxi-mmc.txt b/Documentation/devicetree/bindings/mmc/sunxi-mmc.txt
new file mode 100644
index 0000000..5ce8c5e
--- /dev/null
+++ b/Documentation/devicetree/bindings/mmc/sunxi-mmc.txt
@@ -0,0 +1,32 @@
+* Allwinner sunxi MMC controller
+
+The highspeed MMC host controller on Allwinner SoCs provides an interface
+for MMC, SD and SDIO types of memory cards.
+
+Supported maximum speeds are the ones of the eMMC standard 4.5 as well
+as the speed of SD standard 3.0.
+Absolute maximum transfer rate is 200MB/s
+
+Required properties:
+- compatible: Should be "allwinner,<revision>-<chip>-mmc".
+ The supported chips include a10, a10s, 13, a20 and a31.
+- base registers are 0x1000 appart, so the base of mmc1
+ would be 0x01c0f000+0x1000=0x01c10000(see example)
+ and so on.
+- clocks requires the reference at the ahb clock gate
+ with the correct index (mmc0 -> 8, mmc1 -> 9, and so on)
+ as well as the reference to the correct mod0 clock.
+- interrupts requires the correct IRQ line
+ (mmc0 -> 32, mmc1 -> 33, and so on)
+
+Examples:
+
+mmc0: mmc at 01c0f000 {
+ compatible = "allwinner,sun5i-a13-mmc";
+ reg = <0x01c0f000 0x1000>;
+ clocks = <&ahb_gates 8>, <&mmc0_clk>;
+ clock-names = "ahb", "mod";
+ interrupts = <0 32 4>;
+ bus-width = <4>;
+ status = "disabled";
+};
More information about the linux-arm-kernel
mailing list