[PATCH v7 02/12] mfd: omap-usb-host: Get clocks based on hardware revision
Lee Jones
lee.jones at linaro.org
Fri Feb 14 05:07:01 EST 2014
> Not all revisions have all the clocks so get the necessary clocks
> based on hardware revision.
>
> This should avoid un-necessary clk_get failure messages that were
> observed earlier.
>
> Be more strict and always fail on clk_get() error.
It might have been clearer if you'd broken these two pieces of
functionality changes into two different patches. In future it would
be preferred.
> CC: Lee Jones <lee.jones at linaro.org>
> CC: Samuel Ortiz <sameo at linux.intel.com>
> Signed-off-by: Roger Quadros <rogerq at ti.com>
> ---
> drivers/mfd/omap-usb-host.c | 92 +++++++++++++++++++++++++++++++--------------
> 1 file changed, 64 insertions(+), 28 deletions(-)
>
> diff --git a/drivers/mfd/omap-usb-host.c b/drivers/mfd/omap-usb-host.c
> index 0c3c9a0..60a3bed 100644
> --- a/drivers/mfd/omap-usb-host.c
> +++ b/drivers/mfd/omap-usb-host.c
> @@ -665,22 +665,41 @@ static int usbhs_omap_probe(struct platform_device *pdev)
> goto err_mem;
> }
>
> - need_logic_fck = false;
> + /* Set all clocks as invalid to begin with */
> + omap->ehci_logic_fck = omap->init_60m_fclk = ERR_PTR(-ENODEV);
> + omap->utmi_p1_gfclk = omap->utmi_p2_gfclk = ERR_PTR(-ENODEV);
> + omap->xclk60mhsp1_ck = omap->xclk60mhsp2_ck = ERR_PTR(-ENODEV);
> +
For readability you should probably do these one per line.
> for (i = 0; i < omap->nports; i++) {
> - if (is_ehci_phy_mode(i) || is_ehci_tll_mode(i) ||
> - is_ehci_hsic_mode(i))
> - need_logic_fck |= true;
> + omap->utmi_clk[i] = ERR_PTR(-ENODEV);
> + omap->hsic480m_clk[i] = ERR_PTR(-ENODEV);
> + omap->hsic60m_clk[i] = ERR_PTR(-ENODEV);
> }
>
> - omap->ehci_logic_fck = ERR_PTR(-EINVAL);
> - if (need_logic_fck) {
> - omap->ehci_logic_fck = devm_clk_get(dev, "ehci_logic_fck");
Has this clock been renamed, or is it no longer required?
Perhaps you should be explicit in the commit log as to which clocks
you're removing.
> - if (IS_ERR(omap->ehci_logic_fck)) {
> - ret = PTR_ERR(omap->ehci_logic_fck);
> - dev_dbg(dev, "ehci_logic_fck failed:%d\n", ret);
> + /* for OMAP3 i.e. USBHS REV1 */
> + if (omap->usbhs_rev == OMAP_USBHS_REV1) {
> + need_logic_fck = false;
> + for (i = 0; i < omap->nports; i++) {
> + if (is_ehci_phy_mode(pdata->port_mode[i]) ||
> + is_ehci_tll_mode(pdata->port_mode[i]) ||
> + is_ehci_hsic_mode(pdata->port_mode[i]))
> +
> + need_logic_fck |= true;
> + }
> +
> + if (need_logic_fck) {
> + omap->ehci_logic_fck = clk_get(dev, "usbhost_120m_fck");
devm_clk_get()?
<snip>
--
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
More information about the linux-arm-kernel
mailing list