[RFC PATCH 3/4] ARM: dts: imx6qdl: Allow disabling the PU regulator, add a enable ramp delay

Philipp Zabel p.zabel at pengutronix.de
Tue Feb 11 08:27:10 EST 2014


The PU regulator is enabled during boot, but not necessarily always-on.
It can be disabled by the generic pm domain framework when the PU power
domain is shut down. The ramp delay of 150 us might be a bit conservative,
the value is taken from the Freescale kernel.

Signed-off-by: Philipp Zabel <p.zabel at pengutronix.de>
---
 arch/arm/boot/dts/imx6qdl.dtsi | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/imx6qdl.dtsi b/arch/arm/boot/dts/imx6qdl.dtsi
index fb28b2e..253d82c 100644
--- a/arch/arm/boot/dts/imx6qdl.dtsi
+++ b/arch/arm/boot/dts/imx6qdl.dtsi
@@ -515,7 +515,8 @@
 					regulator-name = "vddpu";
 					regulator-min-microvolt = <725000>;
 					regulator-max-microvolt = <1450000>;
-					regulator-always-on;
+					regulator-enable-ramp-delay = <150>;
+					regulator-boot-on;
 					anatop-reg-offset = <0x140>;
 					anatop-vol-bit-shift = <9>;
 					anatop-vol-bit-width = <5>;
-- 
1.8.5.3




More information about the linux-arm-kernel mailing list