[PATCH] regulator: core: Make regulator object reflect configured voltage

[Bjorn Andersson]

On Tue, Feb 4, 2014 at 12:00 PM, Mark Brown <broonie at kernel.org> wrote:
> On Tue, Feb 04, 2014 at 11:09:03AM -0800, Bjorn Andersson wrote:
>
>> I have a regulator that's being configured from DT as:
>> regulator-min-microvolt = <2950000>;
>> regulator-max-microvolt = <2950000>;
>
>> In the consumer I do regulator_set_voltage(2.95V).
>
>> As min == max the voltage is applied by the regulator framework on registration
>> of the regulator; and the regulator_set_voltage() fails as
>> REGULATOR_CHANGE_VOLTAGE is not set for this regulator.
>
> So we should be changing the code to allow a set_voltage() that sets the
> voltage to the existing voltage regardless of constraints allowing a
> change then - that's what the underlying issue is.  Your change wouldn't
> cover the case where the hardware defualt is being used for example.

Makes sense, but the only thing we could check for would be if min_uV
== max_uV == current-voltage. That would work out fine for this use
case, but do you think it would be good enough?

The best thing I've come up with then is to add the following check in
regulator_set_voltage().

if (min_uV == max_uV && _regulator_get_voltage(rdev) == min_uV)
    goto out;

Would this be acceptable? It's achieving the same thing as my patch,
is more robust and covers the case of setting the voltage to the hw
default value.

Regards,
Bjorn