[PATCH v4 1/8] clk: sunxi: add clock-output-names dt property support

[Chen-Yu Tsai]

sunxi clock drivers use dt node name as clock name, but clock
nodes should be named clk at X, so the names would be the same.
Let the drivers read clock names from dt clock-output-names
property.

Signed-off-by: Chen-Yu Tsai <wens at csie.org>
Acked-by: Maxime Ripard <maxime.ripard at free-electrons.com>
Acked-by: Mike Turquette <mturquette at linaro.org>
---
 drivers/clk/sunxi/clk-sunxi.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/clk/sunxi/clk-sunxi.c b/drivers/clk/sunxi/clk-sunxi.c
index abb6c5a..0ed9794 100644
--- a/drivers/clk/sunxi/clk-sunxi.c
+++ b/drivers/clk/sunxi/clk-sunxi.c
@@ -51,6 +51,8 @@ static void __init sun4i_osc_clk_setup(struct device_node *node)
 	if (!gate)
 		goto err_free_fixed;
 
+	of_property_read_string(node, "clock-output-names", &clk_name);
+
 	/* set up gate and fixed rate properties */
 	gate->reg = of_iomap(node, 0);
 	gate->bit_idx = SUNXI_OSC24M_GATE;
@@ -601,6 +603,8 @@ static void __init sunxi_mux_clk_setup(struct device_node *node,
 	       (parents[i] = of_clk_get_parent_name(node, i)) != NULL)
 		i++;
 
+	of_property_read_string(node, "clock-output-names", &clk_name);
+
 	clk = clk_register_mux(NULL, clk_name, parents, i,
 			       CLK_SET_RATE_NO_REPARENT, reg,
 			       data->shift, SUNXI_MUX_GATE_WIDTH,
@@ -660,6 +664,8 @@ static void __init sunxi_divider_clk_setup(struct device_node *node,
 
 	clk_parent = of_clk_get_parent_name(node, 0);
 
+	of_property_read_string(node, "clock-output-names", &clk_name);
+
 	clk = clk_register_divider(NULL, clk_name, clk_parent, 0,
 				   reg, data->shift, data->width,
 				   data->pow ? CLK_DIVIDER_POWER_OF_TWO : 0,
-- 
1.9.rc1