[PATCH 3.19-rc1 v14 7/8] arm: Seperate DEBUG_UART_PHYS from DEBUG_LL on EP93XX

[Daniel Thompson]

On EP93XX uncompress.h uses CONFIG_DEBUG_UART_PHYS instead of a hard
coded serial port. This means the build breaks when DEBUG_LL
(and DEBUG_LL_UART_PL01X) is not enabled.

This is fixed by adding a new dependency.

Signed-off-by: Daniel Thompson <daniel.thompson at linaro.org>
Acked-by: Arnd Bergmann <arnd at arndb.de>
---
 arch/arm/Kconfig.debug | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
index ff43ea38fe1f..e250505b9ae1 100644
--- a/arch/arm/Kconfig.debug
+++ b/arch/arm/Kconfig.debug
@@ -1370,7 +1370,8 @@ config DEBUG_UART_PHYS
 	default 0xfffb9800 if DEBUG_OMAP1UART3 || DEBUG_OMAP7XXUART3
 	default 0xfffe8600 if DEBUG_UART_BCM63XX
 	default 0xfffff700 if ARCH_IOP33X
-	depends on DEBUG_LL_UART_8250 || DEBUG_LL_UART_PL01X || \
+	depends on ARCH_EP93XX || \
+	        DEBUG_LL_UART_8250 || DEBUG_LL_UART_PL01X || \
 		DEBUG_LL_UART_EFM32 || \
 		DEBUG_UART_8250 || DEBUG_UART_PL01X || DEBUG_MESON_UARTAO || \
 		DEBUG_MSM_UART || DEBUG_NETX_UART || \
-- 
1.9.3