[PATCH] ARM: shmobile: koelsch: add VIN1/ADV7180 DT support

[Sergei Shtylyov]

Hello.

On 08/07/2014 08:01 AM, Magnus Damm wrote:

>> Define the Koelsch board dependent part of the VIN1 device node. Add the device
>> node for Analog  Devices ADV7180  video decoder to  I2C2 bus. Add the necessary
>> subnodes to interconnect VIN1 and ADV7180 devices.

>> Signed-off-by: Sergei Shtylyov <sergei.shtylyov at cogentembedded.com>

>> ---
>> This patch is against the 'renesas-devel-v3.16-20140804' tag of Simon Horman's
>> 'renesas.git' repo. It requires the 'soc_camera' and 'rcar_vin' device tree
>> support patches (already merged to the 'media_tree.git' repo) in order to work.

>>   arch/arm/boot/dts/r8a7791-koelsch.dts |   35 ++++++++++++++++++++++++++++++++++
>>   1 file changed, 35 insertions(+)

>> Index: renesas/arch/arm/boot/dts/r8a7791-koelsch.dts
>> ===================================================================
>> --- renesas.orig/arch/arm/boot/dts/r8a7791-koelsch.dts
>> +++ renesas/arch/arm/boot/dts/r8a7791-koelsch.dts
>> @@ -289,6 +289,11 @@
>>                  renesas,groups = "usb1";
>>                  renesas,function = "usb1";
>>          };
>> +
>> +       vin1_pins: vin1 {
>> +               renesas,groups = "vin1_data8", "vin1_clk";
>> +               renesas,function = "vin1";
>> +       };
>>   };

> Quick question: Does this pin description match to the board layout? I

    Yes, it does.

> suspect that clock and data by themselves are not enough.

    They are enough as BT.656 interconnect is used between VIN1 and ADV7180.

> I'm not sure about Koelsch, but  in case of older SoCs using the CEU
> there were signals used like horizontal and vertical sync and
> sometimes even something that was used to determine interlace.

    The HS and VS/FIELD pins of ADV7180 are left unconnected.  There's also 
ADV7612 connected to VIN0 on this board, there the HSYNC and VSYNC/FIELD pins 
are connected; however, ADV7612 is not supported yet.

> Thanks,

> / magnus

WBR, Sergei