[PATCH 20/97] ARM: l2c: provide enable method
Russell King
rmk+kernel at arm.linux.org.uk
Mon Apr 28 12:27:47 PDT 2014
Providing an enable method gives L2 cache controllers a chance to do
special handling at enable time. This allows us to remove a hack in
l2x0_unlock() for Marvell Aurora L2 caches.
Signed-off-by: Russell King <rmk+kernel at arm.linux.org.uk>
---
arch/arm/mm/cache-l2x0.c | 80 +++++++++++++++++++++++++++++++++++++-----------
1 file changed, 62 insertions(+), 18 deletions(-)
diff --git a/arch/arm/mm/cache-l2x0.c b/arch/arm/mm/cache-l2x0.c
index 09fe0f5eada5..2adb82e7f4b3 100644
--- a/arch/arm/mm/cache-l2x0.c
+++ b/arch/arm/mm/cache-l2x0.c
@@ -29,7 +29,9 @@
#include "cache-aurora-l2.h"
struct l2c_init_data {
+ unsigned num_lock;
void (*of_parse)(const struct device_node *, u32 *, u32 *);
+ void (*enable)(void __iomem *, u32, unsigned);
void (*save)(void __iomem *);
struct outer_cache_fns outer_cache;
};
@@ -82,6 +84,36 @@ static inline void l2c_unlock(void __iomem *base, unsigned num)
}
}
+/*
+ * Enable the L2 cache controller. This function must only be
+ * called when the cache controller is known to be disabled.
+ */
+static void l2c_enable(void __iomem *base, u32 aux, unsigned num_lock)
+{
+ unsigned long flags;
+
+ l2c_unlock(base, num_lock);
+
+ writel_relaxed(aux, base + L2X0_AUX_CTRL);
+
+ local_irq_save(flags);
+ __l2c_op_way(base + L2X0_INV_WAY);
+ writel_relaxed(0, base + sync_reg_offset);
+ l2c_wait_mask(base + sync_reg_offset, 1);
+ local_irq_restore(flags);
+
+ writel_relaxed(L2X0_CTRL_EN, base + L2X0_CTRL);
+}
+
+static void l2c_disable(void)
+{
+ void __iomem *base = l2x0_base;
+
+ outer_cache.flush_all();
+ writel_relaxed(0, base + L2X0_CTRL);
+ dsb(st);
+}
+
#ifdef CONFIG_CACHE_PL310
static inline void cache_wait(void __iomem *reg, unsigned long mask)
{
@@ -325,9 +357,6 @@ static void l2x0_unlock(u32 cache_id)
case L2X0_CACHE_ID_PART_L310:
lockregs = 8;
break;
- case AURORA_CACHE_ID:
- lockregs = 4;
- break;
default:
/* L210 and unknown types */
lockregs = 1;
@@ -337,7 +366,22 @@ static void l2x0_unlock(u32 cache_id)
l2c_unlock(l2x0_base, lockregs);
}
+static void l2x0_enable(void __iomem *base, u32 aux, unsigned num_lock)
+{
+ /* Make sure that I&D is not locked down when starting */
+ l2x0_unlock(readl_relaxed(base + L2X0_CACHE_ID));
+
+ /* l2x0 controller is disabled */
+ writel_relaxed(aux, base + L2X0_AUX_CTRL);
+
+ l2x0_inv_all();
+
+ /* enable L2X0 */
+ writel_relaxed(L2X0_CTRL_EN, base + L2X0_CTRL);
+}
+
static const struct l2c_init_data l2x0_init_fns __initconst = {
+ .enable = l2x0_enable,
.outer_cache = {
.inv_range = l2x0_inv_range,
.clean_range = l2x0_clean_range,
@@ -412,22 +456,11 @@ static void __init __l2c_init(const struct l2c_init_data *data,
l2x0_size = ways * way_size * SZ_1K;
/*
- * Check if l2x0 controller is already enabled.
- * If you are booting from non-secure mode
- * accessing the below registers will fault.
+ * Check if l2x0 controller is already enabled. If we are booting
+ * in non-secure mode accessing the below registers will fault.
*/
- if (!(readl_relaxed(l2x0_base + L2X0_CTRL) & L2X0_CTRL_EN)) {
- /* Make sure that I&D is not locked down when starting */
- l2x0_unlock(cache_id);
-
- /* l2x0 controller is disabled */
- writel_relaxed(aux, l2x0_base + L2X0_AUX_CTRL);
-
- l2x0_inv_all();
-
- /* enable L2X0 */
- writel_relaxed(L2X0_CTRL_EN, l2x0_base + L2X0_CTRL);
- }
+ if (!(readl_relaxed(l2x0_base + L2X0_CTRL) & L2X0_CTRL_EN))
+ data->enable(l2x0_base, aux, data->num_lock);
/* Re-read it in case some bits are reserved. */
aux = readl_relaxed(l2x0_base + L2X0_AUX_CTRL);
@@ -515,6 +548,7 @@ static void l2x0_resume(void)
static const struct l2c_init_data of_l2x0_data __initconst = {
.of_parse = l2x0_of_parse,
+ .enable = l2x0_enable,
.outer_cache = {
.inv_range = l2x0_inv_range,
.clean_range = l2x0_clean_range,
@@ -620,7 +654,9 @@ static void pl310_resume(void)
}
static const struct l2c_init_data of_pl310_data __initconst = {
+ .num_lock = 8,
.of_parse = pl310_of_parse,
+ .enable = l2c_enable,
.save = pl310_save,
.outer_cache = {
.inv_range = l2x0_inv_range,
@@ -779,7 +815,9 @@ static void __init aurora_of_parse(const struct device_node *np,
}
static const struct l2c_init_data of_aurora_with_outer_data __initconst = {
+ .num_lock = 4,
.of_parse = aurora_of_parse,
+ .enable = l2c_enable,
.save = aurora_save,
.outer_cache = {
.inv_range = aurora_inv_range,
@@ -793,7 +831,9 @@ static const struct l2c_init_data of_aurora_with_outer_data __initconst = {
};
static const struct l2c_init_data of_aurora_no_outer_data __initconst = {
+ .num_lock = 4,
.of_parse = aurora_of_parse,
+ .enable = l2c_enable,
.save = aurora_save,
.outer_cache = {
.resume = aurora_resume,
@@ -942,7 +982,9 @@ static void bcm_flush_range(unsigned long start, unsigned long end)
}
static const struct l2c_init_data of_bcm_l2x0_data __initconst = {
+ .num_lock = 8,
.of_parse = pl310_of_parse,
+ .enable = l2c_enable,
.save = pl310_save,
.outer_cache = {
.inv_range = bcm_inv_range,
@@ -976,6 +1018,8 @@ static void tauros3_resume(void)
}
static const struct l2c_init_data of_tauros3_data __initconst = {
+ .num_lock = 8,
+ .enable = l2c_enable,
.save = tauros3_save,
/* Tauros3 broadcasts L1 cache operations to L2 */
.outer_cache = {
--
1.8.3.1
More information about the linux-arm-kernel
mailing list