[PATCH] ARM: dts: Remove vmmc-supply for mmc at 12220000 on arndale-octa board

[Tomasz Figa]

On 25.04.2014 22:30, Javi Merino wrote:
> On Fri, Apr 25, 2014 at 09:16:30PM +0100, Tomasz Figa wrote:
>> Hi Javi,
>>
>> On 25.04.2014 22:11, Javi Merino wrote:
>>> d726ca2d3316 (ARM: dts: Add vmmc-supply to MMC on arndale-octa board)
>>> added the vmmc-supply to nodes mmc at 12200000 and mmc at 12220000 of the
>>> DT.  However, this makes the kernel fail to boot on the arndale-octa
>>> spews:
>>>
>>> [    5.060000] dwmmc_exynos 12200000.mmc: num-slots property not found, assuming 1 slot is available
>>> [    5.065000] platform 12200000.mmc: Driver dwmmc_exynos requests probe deferral
>>> [    5.075000] dwmmc_exynos 12220000.mmc: num-slots property not found, assuming 1 slot is available
>>> [    5.085000] platform 12220000.mmc: Driver dwmmc_exynos requests probe deferral
>>>
>>> And eventually hangs.  Without the vmmc-supply property in the
>>> mmc at 12220000 node, the kernel boots again.
>>>
>>> Signed-off-by: Javi Merino <javi.merino at arm.com>
>>> ---
>>>
>>> Hi,
>>>
>>> Note that I don't know *why* removing the property works, all I know
>>> is that 3.15-rc2 fails to boot on my Arndale Octa unless I apply this
>>> patch.
>>
>> Are you sure you have the required PMIC driver enabled in your kernel
>> config?
>
> I configured the kernel using exynos_defconfig and that gives me:
>
> # CONFIG_PMIC_ADP5520 is not set
> # CONFIG_PMIC_DA903X is not set
>
> Should I be using other defconfig for this board?  exynos_defconfig
> used to work in 3.14.  Cheers,

Well, unfortunately exynos_defconfig is known to be far from being 
reasonable. Right now it should be considered just as a base to 
configure the kernel for Exynos SoCs. Most of board specific options 
(and many of SoC-wide ones) need to be selected manually.

Anyway, with the number of Exynos boards supported in mainline, I don't 
think we will be ever going to enable all options for all the supported 
boards by default in defconfig, especially considering the fact that we 
will be moving to generic multi_v7_defconfig and likely dropping 
exynos_defconfig completely.

As for now, I believe you should just make sure yourself that any 
options relevant to your board are enabled.

Best regards,
Tomasz