[PATCHv3 19/41] OMAPDSS: panel-dpi: Add DT support

[Laurent Pinchart]

Hi Tomi,

On Thursday 24 April 2014 12:52:42 Tomi Valkeinen wrote:
> On 18/04/14 18:51, Tony Lindgren wrote:
> >> +	gpio = of_get_gpio(node, 0);
> >> +	if (gpio_is_valid(gpio) || gpio == -ENOENT) {
> >> +		ddata->enable_gpio = gpio;
> >> +	} else {
> >> +		dev_err(&pdev->dev, "failed to parse enable gpio\n");
> >> +		return gpio;
> >> +	}
> > 
> > We should set the GPIO polarity based on the OF_GPIO_ACTIVE_LOW like
> > gpio_backlight_probe_dt is doing.
> 
> Instead of doing it with the old gpio API, and checking the 'active'
> flag everywhere, I think we can use the new gpiod API which handles the
> polarity automatically.
> 
> I attached prototype patches (based on -rc2) for panel dpi using that
> approach. It's a bit messier than I'd like, because for non-DT boot we
> need to request the gpio using the old API, and then convert it to
> gpio_desc. We can remove that code when all the boards use DT.

Just FYI, you can use the gpiod API with non-DT platforms if you register GPIO 
lookup entries in board code with gpiod_add_lookup_table().

> I've compiled tested this only, as I don't have DPI panels I could use.
> I did try similar approach for TFP410, and it seemed to work fine.

-- 
Regards,

Laurent Pinchart
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 490 bytes
Desc: This is a digitally signed message part.
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20140424/d48b2c9b/attachment.sig>