[PATCH 14/33] ARM: shmobile: koelsch: Set ethernet PHY LED mode

[Simon Horman]

From: Laurent Pinchart <laurent.pinchart+renesas at ideasonboard.com>

The Koelsch board uses the ethernet PHY LED0 as a link signal connected
to the ethernet controller. Specify the corresponding LED mode for the
PHY.

Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas at ideasonboard.com>
Signed-off-by: Simon Horman <horms+renesas at verge.net.au>
---
 arch/arm/boot/dts/r8a7791-koelsch.dts | 1 +
 1 file changed, 1 insertion(+)

diff --git a/arch/arm/boot/dts/r8a7791-koelsch.dts b/arch/arm/boot/dts/r8a7791-koelsch.dts
index fd1d6ee..ee23b7b 100644
--- a/arch/arm/boot/dts/r8a7791-koelsch.dts
+++ b/arch/arm/boot/dts/r8a7791-koelsch.dts
@@ -297,6 +297,7 @@
 		reg = <1>;
 		interrupt-parent = <&irqc0>;
 		interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
+		micrel,led-mode = <1>;
 	};
 };
 
-- 
1.8.5.2