[PATCH v8 2/3] net: hisilicon: new hip04 MDIO driver

[zhangfei]

On 04/22/2014 10:30 PM, Arnd Bergmann wrote:
> On Tuesday 22 April 2014, zhangfei wrote:
>> On 04/22/2014 04:22 PM, Arnd Bergmann wrote:
>>
>>>> It's private register of the phy marvell 88e1512.
>>>> To make it clearer using define instead.
>>>> #define MII_MARVELL_PHY_PAGE    22
>>>>
>>>> The registers has been grouped into several pages, access register need
>>>> choose which page first.
>>>
>>> You shouldn't touch the PHY private registers in the main driver though,
>>> this should be purely handled by drivers/net/phy/marvell.c.
>>>
>>> I don't see support for 88e1512 there, only 88e1510 and lots of older
>>> ones, but I assume it isn't hard to add.
>>>
>>
>> 88e1512 driver is already supported, same as 88e1510.
>> #define MARVELL_PHY_ID_MASK             0xfffffff0
>> So it should support 88e151x.
>>
>> Reset is required here for get_phy_id, otherwise only 0 can be get.
>> phy_device_create will not be called, and can not match any driver.
>>
>> However in the experiment, it is found BMCR_RESET is not required in fact.
>> Only hip04_mdio_write(bus, i, MII_MARVELL_PHY_PAGE, 0) has to be set.
>> 88e151x registers are divided into pages.
>> Generic MII registers is in page 0, including MII_PHYSID1 and MII_PHYSID2.
>> Unfortunately the default page is not 0, so get_phy_id will fail.
>>
>> So bus->reset still required to set the page to 0, prepared for get_phy_id.
>
> But it means that the hip04_mdio driver potentially won't work if connected
> to something other than a Marvell PHY.
>
> I noticed that the marvell_of_reg_init() does this at init time:
>
> saved_page = phy_read(phydev, MII_MARVELL_PHY_PAGE);
> ... /* perform init */
> if (page_changed)
> 	phy_write(phydev, MII_MARVELL_PHY_PAGE, saved_page);
>
> Is this a bug? Maybe it should always set page 0 when leaving
> this function.
>
It is correct behavior return to the original page.

First get_phy_id, then match driver according to the id, then operation 
in the specific driver have the chance to run, including 
marvell_of_reg_init etc.

Just unlucky the default value of PHY_PAGE after power on is not 0.

Thanks