[PATCH v2 2/4] Documentation: dts: Add bindings for APM X-Gene SoC ethernet driver

[Sergei Shtylyov]

Hello.

On 04/12/2014 07:06 AM, Iyappan Subramanian wrote:

> This patch adds documentation for APM X-Gene SoC ethernet DTS binding.

> Signed-off-by: Iyappan Subramanian <isubramanian at apm.com>
> Signed-off-by: Ravi Patel <rapatel at apm.com>
> Signed-off-by: Keyur Chudgar <kchudgar at apm.com>
> ---
>   .../devicetree/bindings/net/apm-xgene-enet.txt     |   46 ++++++++++++++++++++
>   1 file changed, 46 insertions(+)
>   create mode 100644 Documentation/devicetree/bindings/net/apm-xgene-enet.txt

> diff --git a/Documentation/devicetree/bindings/net/apm-xgene-enet.txt b/Documentation/devicetree/bindings/net/apm-xgene-enet.txt
> new file mode 100644
> index 0000000..0c983e8
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/apm-xgene-enet.txt
> @@ -0,0 +1,46 @@
> +APM X-Gene SoC Ethernet nodes
> +
> +Ethernet nodes are defined to describe on-chip ethernet interfaces in
> +APM X-Gene SoC.
> +
> +Required properties:
> +- compatible		: Should be "apm,xgene-enet"
> +- reg			: First resource is the ethernet base register set
> +			  Second resource is the ring base register set
> +			  Third resource is the ring command register set
> +- interrupts		: Ethernet main interrupt
> +- clocks		: Reference to the clock entry.
> +- local-mac-address	: Ethernet MAC address.

    This property is described in 
Documentation/devicetree/bindings/net/ethernet.txt, please refer to it.

> +- phy-addr		: Ethernet MII phy address.

    No, thus won't do. Please use "phy-handle" property to refer to a PHY subnode.

> +- phy-mode		: Ethernet MII mode.

    This one is described in 
Documentation/devicetree/bindings/net/ethernet.txt as well.

WBR, Sergei