[PATCH 4/4] ARM: tegra: fix Venice2 VQMMC regulators

[Chris Ball]

Hi Stephen,

On Tue, Apr 15 2014, Stephen Warren wrote:
> Is there documentation re: what vmmc-supply and vqmmc-supply actually
> refer to? I looked a long while ago and couldn't find any, and didn't
> get an answer when I asked.
>
> Neither
> Documentation/devicetree/bindings/mmc/{mmc.txt,nvidia,tegra20-sdhci.txt}
> seem to say:-(

MMC cards use the same voltage for the VDD pin on the card and to pull
up the signal lines.  UHS SDHCI switches to using 1.8V vqmmc (signaling
voltage) and 3.3V vmmc (card supply voltage).

So the idea is to supply a vqmmc-supply if your board supports
ultra-high-speed modes on an SD 3.0 host, and a vmmc-supply if your
card power is controlled by a regulator.  I agree that this ought to
be in the bindings somewhere.

Thanks,

- Chris.
-- 
Chris Ball   <http://printf.net/>