[PATCH v2] ARM: perf: save/restore pmu registers in pm notifier

[Neil Zhang]

> -----Original Message-----
> From: Will Deacon [mailto:will.deacon at arm.com]
> Sent: 2014年4月15日 20:41
> To: Neil Zhang
> Cc: linux at arm.linux.org.uk; linux-arm-kernel at lists.infradead.org;
> linux-kernel at vger.kernel.org; Sudeep Holla
> Subject: Re: [PATCH v2] ARM: perf: save/restore pmu registers in pm notifier
> 
> On Tue, Apr 15, 2014 at 01:37:17PM +0100, Neil Zhang wrote:
> > > On Mon, Apr 14, 2014 at 02:42:22AM +0100, Neil Zhang wrote:
> > > > From: Sudeep KarkadaNagesha <sudeep.karkadanagesha at arm.com>
> > > >
> > > > This adds core support for saving and restoring CPU PMU registers
> > > > for suspend/resume support i.e. deeper C-states in cpuidle terms.
> > > > This patch adds support only to ARMv7 PMU registers save/restore.
> > > > It needs to be extended to xscale and ARMv6 if needed.
> > > >
> > > > [Neil] We found that DS-5 not work on our CA7 based SoCs.
> > > > After debuging, found PMU registers were lost because of core power
> down.
> > > > Then i found Sudeep had a patch to fix it about two years ago but
> > > > not in the mainline, just port it.
> > >
> > > What I don't like about this patch is that we're introducing
> > > significant overhead for SoCs that don't require save/restore of the
> > > PMU state. I'd much rather see core power down disabled whilst the
> > > PMU is in use but, if that's not possible, then I think we need to:
> > >
> > >  (1) Make this conditional for cores that really need it
> > >
> > >  (2) Only save/restore if the PMU is in use (even better, just save/restore
> > >      the live registers, but that's probably not worth the effort
> > >      initially).
> > >
> >
> > The patch has check the ARMV7_PMNC_E bit when save / restore, so
> > suppose only the core's that use PMU will do the save / restore work.
> 
> Seems pretty fragile to base our save/restore decision on the value of one of
> the registers, though. What happens if the control register is zeroed by the
> core power down?
> 
It will check the saved control value when restore, so is should be OK while control register is zeroed. 

> Will

Best Regards,
Neil Zhang