[PATCH 1/5] spi: sirf: correct TXFIFO empty interrupt status bit

[Barry Song]

From: Qipan Li <Qipan.Li at csr.com>

the old code uses wrong marco - SIRFSOC_SPI_FIFO_FULL is not for
FIFO interrupt status, it is for FIFO status. here in the ISR,
SIRFSOC_SPI_TXFIFO_EMPTY is the right bit for SPI TXFIFO interrupt
status.

Signed-off-by: Qipan Li <Qipan.Li at csr.com>
Signed-off-by: Barry Song <Baohua.Song at csr.com>
---
 drivers/spi/spi-sirf.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-sirf.c b/drivers/spi/spi-sirf.c
index 1a77ad5..51d7c98 100644
--- a/drivers/spi/spi-sirf.c
+++ b/drivers/spi/spi-sirf.c
@@ -287,8 +287,8 @@ static irqreturn_t spi_sirfsoc_irq(int irq, void *dev_id)
 				sspi->left_rx_word)
 			sspi->rx_word(sspi);
 
-	if (spi_stat & (SIRFSOC_SPI_FIFO_EMPTY
-			| SIRFSOC_SPI_TXFIFO_THD_REACH))
+	if (spi_stat & (SIRFSOC_SPI_TXFIFO_EMPTY |
+			SIRFSOC_SPI_TXFIFO_THD_REACH))
 		while (!((readl(sspi->base + SIRFSOC_SPI_TXFIFO_STATUS)
 				& SIRFSOC_SPI_FIFO_FULL)) &&
 				sspi->left_tx_word)
-- 
1.7.5.4