[PATCH 05/11] ARM: dts: Configure omap3 twl4030 I2C4 pins by default

[Tony Lindgren]

Almost certainly any sane board has the twl4030 has the I2C4
pins connected as those are needed for voltage control during
idle. If the I2C4 lines are not properly muxed, any voltage
scaling over I2C4 will fail.

Let's mux those pins by default, the boards that are not using
them can still configure things separately.

Cc: Kevin Hilman <khilman at linaro.org>
Cc: Nishanth Menon <nm at ti.com>
Cc: Paul Walmsley <paul at pwsan.com>
Cc: Tero Kristo <t-kristo at ti.com>
Signed-off-by: Tony Lindgren <tony at atomide.com>
---
 arch/arm/boot/dts/twl4030_omap3.dtsi | 19 ++++++++++++++++++-
 1 file changed, 18 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/twl4030_omap3.dtsi b/arch/arm/boot/dts/twl4030_omap3.dtsi
index c353ef0..3537ae5 100644
--- a/arch/arm/boot/dts/twl4030_omap3.dtsi
+++ b/arch/arm/boot/dts/twl4030_omap3.dtsi
@@ -8,7 +8,7 @@
 
 &twl {
 	pinctrl-names = "default";
-	pinctrl-0 = <&twl4030_pins>;
+	pinctrl-0 = <&twl4030_pins &twl4030_vpins>;
 };
 
 &omap3_pmx_core {
@@ -23,3 +23,20 @@
 		>;
 	};
 };
+
+/*
+ * If your board is not using the I2C4 pins with twl4030, then don't include
+ * this file. For proper idle mode signaling with sys_clkreq and sys_off_mode
+ * pins we need to configure I2C4, or else use the legacy sys_nvmode1 and
+ * sys_nvmode2 signaling.
+ */
+&omap3_pmx_wkup {
+	twl4030_vpins: pinmux_twl4030_vpins {
+		pinctrl-single,pins = <
+			OMAP3_WKUP_IOPAD(0x2a00, PIN_INPUT | MUX_MODE0)		/* i2c4_scl.i2c4_scl */
+			OMAP3_WKUP_IOPAD(0x2a02, PIN_INPUT | MUX_MODE0)		/* i2c4_sda.i2c4_sda */
+			OMAP3_WKUP_IOPAD(0x2a06, PIN_OUTPUT | MUX_MODE0)	/* sys_clkreq.sys_clkreq */
+			OMAP3_WKUP_IOPAD(0x2a18, PIN_OUTPUT | MUX_MODE0)	/* sys_off_mode.sys_off_mode */
+		>;
+	};
+};
-- 
1.8.1.1