[PATCH] pwm: mxs: set pwm_chip can_sleep flag

[Russell King - ARM Linux]

On Wed, Apr 09, 2014 at 11:41:17AM +0800, Shawn Guo wrote:
> On Wed, Apr 09, 2014 at 12:44:18AM +0100, Russell King - ARM Linux wrote:
> > On Wed, Apr 09, 2014 at 01:16:54AM +0200, Alexandre Belloni wrote:
> > > I'm not home, else I'll try on my i.mx28 boards...
> > 
> > I just tried heartbeat here, on iMX6, and it works fine.  That's with this
> > in the DT:
> 
> FYI. i.MX28 is known as 'mxs' sub-architecture and uses pwm-mxs driver
> rather than pwm-imx which is the one for i.MX6.

My point being by doing the above test is that the pwm_disable() call
in leds-pwm works correctly with iMX6 and the "troublesome" active-low
flag set at the leds-pwm level.

It wouldn't work on iMX6 if you tried to use the broken inversion on the
PWM output - it would have exactly the effects being reported on iMX28
as setting a duty of 100% would pull the signal low and disabling the PWM
will also pull the signal low (which are the two states heartbeat uses.)

-- 
FTTC broadband for 0.8mile line: now at 9.7Mbps down 460kbps up... slowly
improving, and getting towards what was expected from it.