[PATCH 3/4] spi: davinci: Allow SPI to be build without EDMA support

[Santosh Shilimkar]

On Monday 30 September 2013 10:38 AM, Mark Brown wrote:
> On Mon, Sep 30, 2013 at 09:36:23AM -0400, Santosh Shilimkar wrote:
>> On Sunday 29 September 2013 08:31 AM, Mark Brown wrote:
> 
>>> If there's no hard dependency on EDMA then the driver probably ought to
>>> be marked as COMPILE_TEST so that it can be build tested on other
>>> systems.  Is that possible?
> 
>> EDMA is already getting tested for DAVINCI builds and there are patches
>> coming AMXXXX SOC support. So probably marking it COMPILE_TEST isn't
>> needed since it has been in use already for other SOCs.
> 
> It'd make life easier for general subsystem development if we were able
> to get build coverage without having to build a specific config, even if
> it's never actually going to be run.
> 
So after your comments, I actually checked whether the driver works with
EDMA enabled but no EDMA node/data information from DT for SPI driver.
It seems to work.

So I am going to drop this patch and rather allow the EDMA to be built
for Keystone SOCs as well. Not sure why I didn't looked at this as an
option first place.

Thanks for your comments Mark.

Regards,
Santosh