[RFC PATCH] imx: video: staging: Add HDMI support to imx-drm driver

[Tony Prisk]

On 28/09/13 15:52, Fabio Estevam wrote:
> Hi Tony,
>
> [Fix ARM kernel mailing list address that was wrong in your first email]
>
> On Sat, Aug 10, 2013 at 5:15 PM, Tony Prisk <linux at prisktech.co.nz> wrote:
>> On 11/08/13 05:52, Fabio Estevam wrote:
>> Thanks for the review.. Most of this is expected. I hadn't spent a lot of
>> time tidying up or 'formalizing' the patch, but I will tidy up the comments
>> you made.
>>
>> Three problem's I have noticed with the driver are:
>>
>> 1) If I start the system with no output connected, then connect the hdmi,
>> the framebuffer is initialized in 1024x768, but the connector/encoder is in
>> 1920x1080 (as per the video= kernel param).
>>
>> 2) The PLL fails to lock several times during startup, but always seems to
>> be ok to initialize the actually requested mode.
>>
>> 3) EDID reading fails occassionally for no obvious reason. Powering down the
>> Wandboard (sometimes several times) and it comes right.
>>
>> Once I get all this sorted out, and the code tidied up properly I will send
>> a 'proper' patch.
> Do you still plan to submitting the HDMI driver for mx6?
>
> Regards,
>
> Fabio Estevam
Sorry... I've been tied up with work a lot lately and haven't had a lot 
of time to spend on it.
I still haven't been able to overcome the problem with the resolutions 
at 108Mhz, otherwise it seems to work pretty well. I expect it will be a 
while yet before I can spend any serious time on it, so if someone else 
wants to work through the problem and submit a patch, feel free.

Regards
Tony Prisk