[PATCH 1/1] arm64: X-Gene AHBC platform bus driver

Marc Zyngier marc.zyngier at arm.com
Fri Sep 27 04:47:42 EDT 2013


Hi Feng,

On 2013-09-27 02:19, Feng Kan wrote:
> This driver setup the AHBC for SPI and SD drivers to use.

That's a bit thin for a description. What is AHBC? How does it relate 
to SPI and SD? How is it used?

> Signed-off-by: Feng Kan <fkan at apm.com>
>
> ---
>  arch/arm64/boot/dts/apm-storm.dtsi |    6 +
>  drivers/bus/Kconfig                |    9 ++
>  drivers/bus/Makefile               |    2 +
>  drivers/bus/xgene_ahbc.c           |  193
> ++++++++++++++++++++++++++++++++++++
>  4 files changed, 210 insertions(+), 0 deletions(-)
>  create mode 100644 drivers/bus/xgene_ahbc.c
>
> diff --git a/arch/arm64/boot/dts/apm-storm.dtsi
> b/arch/arm64/boot/dts/apm-storm.dtsi
> index d994806..b9477ec 100644
> --- a/arch/arm64/boot/dts/apm-storm.dtsi
> +++ b/arch/arm64/boot/dts/apm-storm.dtsi
> @@ -178,6 +178,12 @@
>  			};
>  		};
>
> +                ahbc: ahbc at 1f2a0000 {
> +                        device_type = "ahbc";
> +                        compatible = "apm,xgene-ahbc";
> +                        reg =  <0x0 0x1f2a0000 0x0 0x80000>;
> +                };

Where is the binding documentation for this?

>  		serial0: serial at 1c020000 {
>  			device_type = "serial";
>  			compatible = "ns16550";
> diff --git a/drivers/bus/Kconfig b/drivers/bus/Kconfig
> index 1f70e84..6cc361c68 100644
> --- a/drivers/bus/Kconfig
> +++ b/drivers/bus/Kconfig
> @@ -42,4 +42,13 @@ config ARM_CCI
>  	help
>  	  Driver supporting the CCI cache coherent interconnect for ARM
>  	  platforms.
> +
> +config XGENE_AHBC
> +	tristate "X-Gene SoC AHB Bus Driver"
> +	depends on ARM64 && ARCH_XGENE
> +	default y if ARCH_XGENE
> +	help
> +	  X-Gene SoC AHB bus driver is required for SPI and
> +	  SDIO to function properly.
> +
>  endmenu
> diff --git a/drivers/bus/Makefile b/drivers/bus/Makefile
> index 8947bdd..0c7a4ca 100644
> --- a/drivers/bus/Makefile
> +++ b/drivers/bus/Makefile
> @@ -10,3 +10,5 @@ obj-$(CONFIG_OMAP_OCP2SCP)	+= omap-ocp2scp.o
>  obj-$(CONFIG_OMAP_INTERCONNECT)	+= omap_l3_smx.o omap_l3_noc.o
>  # CCI cache coherent interconnect for ARM platforms
>  obj-$(CONFIG_ARM_CCI)		+= arm-cci.o
> +
> +obj-$(CONFIG_XGENE_AHBC)     += xgene_ahbc.o
> diff --git a/drivers/bus/xgene_ahbc.c b/drivers/bus/xgene_ahbc.c
> new file mode 100644
> index 0000000..9554bb4
> --- /dev/null
> +++ b/drivers/bus/xgene_ahbc.c
> @@ -0,0 +1,193 @@
> +/**
> + * AppliedMicro X-Gene AHBC Driver
> + *
> + * Copyright (c) 2013, Applied Micro Circuits Corporation
> + * Author: Loc Ho <lho at apm.com>
> + * Author: Feng Kan <fkan at apm.com>
> + *
> + * This program is free software; you can redistribute it and/or
> + * modify it under the terms of the GNU General Public License as
> + * published by the Free Software Foundation; either version 2 of
> + * the License, or (at your option) any later version.
> + *
> + * This program is distributed in the hope that it will be useful,
> + * but WITHOUT ANY WARRANTY; without even the implied warranty of
> + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
> + * GNU General Public License for more details.
> + *
> + * You should have received a copy of the GNU General Public License
> + * along with this program; if not, write to the Free Software
> + * Foundation, Inc., 59 Temple Place, Suite 330, Boston,
> + * MA 02111-1307 USA
> + *
> + */
> +#include <linux/module.h>
> +#include <linux/io.h>
> +#include <linux/clk.h>
> +#include <linux/of_platform.h>
> +#include <linux/of_address.h>
> +#include <linux/delay.h>
> +#include <linux/memblock.h>
> +
> +#define AHBC_DRIVER_VER			"0.1"
> +
> +#define AIM_8_SIZE_CTL_ADDR					0x00000104
> +#define AIM_8_AXI_LO_ADDR					0x00000108
> +#define AIM_8_AXI_HI_ADDR					0x0000010c
> +
> +#define ARSB_F8_WR(src)			(((u32)(src)<<23) & 0x03800000)
> +#define AWSB_F8_WR(src)			(((u32)(src)<<20) & 0x00700000)
> +#define AIM_AXI_ADDRESS_LO_8_WR(src)	(((u32)(src)) & 0x000fffff)
> +
> +/*	Global Base Address	*/
> +#define REGSPEC_AHBC_GLBL_DIAG_CSR_I_BASE_ADDR			0x01f2ad000ULL

Global base address? Why isn't this part of your DT binding? Or is it 
always included in the reg property? In any case, nuke this #define.

> +#define REGSPEC_CFG_MEM_RAM_SHUTDOWN_ADDR			0x00000070
> +#define REGSPEC_BLOCK_MEM_RDY_ADDR				0x00000074
> +
> +static void xgene_ahb_write(void *base, u32 offset, u32 val)
> +{
> +	if (base == NULL)
> +		return;
> +
> +	writel_relaxed(val, base + offset);
> +}
> +
> +static void xgene_ahbc_init_mem(struct platform_device *pdev)
> +{
> +	void *ahbc_base = platform_get_drvdata(pdev);
> +	u32 diag_offset = REGSPEC_AHBC_GLBL_DIAG_CSR_I_BASE_ADDR & 0xFFFF;

So diag_offset is always 0xd000?

> +	void *diagcsr_base = ahbc_base + diag_offset;
> +	int timeout;
> +	u32 val;
> +
> +	if (ahbc_base == NULL)
> +		return;
> +
> +	if (readl(diagcsr_base + REGSPEC_CFG_MEM_RAM_SHUTDOWN_ADDR) == 0)
> +		return;
> +
> +	dev_dbg(&pdev->dev, "AHBC clear memory shutdown\n");
> +	writel(0x00, diagcsr_base + REGSPEC_CFG_MEM_RAM_SHUTDOWN_ADDR);
> +	readl(diagcsr_base + REGSPEC_CFG_MEM_RAM_SHUTDOWN_ADDR);
> +
> +	val = readl(diagcsr_base + REGSPEC_BLOCK_MEM_RDY_ADDR);
> +	timeout = 5000;
> +	while (val != 0xFFFFFFFF && timeout-- > 0) {
> +		val = readl(diagcsr_base + REGSPEC_BLOCK_MEM_RDY_ADDR);
> +		if (val != 0xFFFFFFFF)
> +			udelay(1);
> +	}
> +	if (timeout <= 0)
> +		dev_err(&pdev->dev, "AHBC failed to remove RAM out of reset\n");

In that case, why not report the error to the caller?

> +}
> +
> +static int xgene_ahbc_hw_init(struct platform_device *pdev)
> +{
> +	void *ahbc_base = platform_get_drvdata(pdev);
> +	phys_addr_t ddr_phy;
> +
> +	/**
> +	 * Set AHBC AIM windows for 4GB regardless of DDR size. This
> +	 * must map to Kernel memory space.
> +	 */
> +	ddr_phy = memblock_phys_mem_size();
> +	dev_dbg(&pdev->dev, "Setup AHBC AIM windows DDR 0x%llX\n", 
> ddr_phy);
> +	xgene_ahb_write(ahbc_base, AIM_8_SIZE_CTL_ADDR, 0x00000000);
> +	xgene_ahb_write(ahbc_base, AIM_8_AXI_LO_ADDR,
> +			ARSB_F8_WR(1) | AWSB_F8_WR(1) |
> +			AIM_AXI_ADDRESS_LO_8_WR((u32) ddr_phy));
> +	xgene_ahb_write(ahbc_base, AIM_8_AXI_HI_ADDR,
> +			(u32) ((ddr_phy >> 32) << 20));
> +
> +	return 0;
> +}
> +
> +static int __init xgene_ahbc_probe(struct platform_device *pdev)
> +{
> +	struct resource res;
> +	int rc;
> +	void *reg;
> +
> +	rc = of_address_to_resource(pdev->dev.of_node, 0, &res);
> +	if (rc != 0) {
> +		dev_err(&pdev->dev, "invalid resource address\n");
> +		return -ENODEV;
> +	}
> +	reg = ioremap(res.start, res.end - res.start + 1);
> +	if (reg == NULL) {
> +		dev_err(&pdev->dev, "can not map resource\n");
> +		return -ENODEV;
> +	}

Use of_iomap instead of dealing with resources yourself.

> +
> +	platform_set_drvdata(pdev, reg);
> +
> +	/* Initialize the hardware */
> +	xgene_ahbc_init_mem(pdev);
> +	xgene_ahbc_hw_init(pdev);
> +
> +	dev_info(&pdev->dev, "AHBC driver v%s\n", AHBC_DRIVER_VER);
> +	return 0;
> +}
> +
> +static int xgene_ahbc_remove(struct platform_device *pdev)
> +{
> +	void *ahbc_base = platform_get_drvdata(pdev);
> +
> +	iounmap(ahbc_base);
> +	platform_set_drvdata(pdev, NULL);
> +	return 0;
> +}
> +
> +#if defined(CONFIG_PM)
> +static int xgene_ahbc_suspend(struct platform_device *dev,
> pm_message_t state)
> +{
> +	/* Nothing to do here */
> +	return 0;
> +}
> +
> +static int xgene_ahbc_resume(struct platform_device *pdev)
> +{
> +	/* Initialize the hardware */
> +	xgene_ahbc_init_mem(pdev);
> +	xgene_ahbc_hw_init(pdev);
> +	return 0;
> +}
> +#endif
> +
> +static const struct of_device_id xgene_ahbc_match[] = {
> +	{.compatible = "apm,xgene-ahbc",},
> +	{},
> +};
> +
> +MODULE_DEVICE_TABLE(of, xgene_ahbc_match);
> +
> +static struct platform_driver ahbc_driver = {
> +	.probe = xgene_ahbc_probe,
> +	.remove = xgene_ahbc_remove,
> +#if defined(CONFIG_PM)
> +	.suspend = xgene_ahbc_suspend,
> +	.resume = xgene_ahbc_resume,
> +#endif

It would be nicer to define xgene_ahbc_{suspend,ersume} to NULL if 
!CONFIG_PM.

> +	.driver = {
> +		   .name = "xgene-ahbc",
> +		   .owner = THIS_MODULE,
> +		   .of_match_table = xgene_ahbc_match,
> +		   },
> +};
> +
> +static int __init xgene_ahbc_init(void)
> +{
> +	return platform_driver_register(&ahbc_driver);
> +}
> +subsys_initcall(xgene_ahbc_init);
> +
> +static void __exit xgene_ahbc_exit(void)
> +{
> +	platform_driver_unregister(&ahbc_driver);
> +}
> +module_exit(xgene_ahbc_exit);
> +
> +MODULE_AUTHOR("Loc Ho <lho at apm.com>");
> +MODULE_DESCRIPTION("X-Gene AHBC driver");
> +MODULE_LICENSE("GPL");

Cheers,

         M.
-- 
Fast, cheap, reliable. Pick two.



More information about the linux-arm-kernel mailing list