[RFC PATCH 06/15] phy: omap-pipe3: update compatibility string and DT binding

[Roger Quadros]

Improve compatibility string format to "ti,phy-pipe3-<type>"
where <type> can be "usb3" or "sata". Remove "pcie" type
as it is not yet supported due to missing DPLL data.

Signed-off-by: Roger Quadros <rogerq at ti.com>
---
 Documentation/devicetree/bindings/phy/omap-phy.txt |    3 +--
 drivers/phy/phy-omap-pipe3.c                       |    8 ++------
 2 files changed, 3 insertions(+), 8 deletions(-)

diff --git a/Documentation/devicetree/bindings/phy/omap-phy.txt b/Documentation/devicetree/bindings/phy/omap-phy.txt
index cf45b01..8e09ad3 100644
--- a/Documentation/devicetree/bindings/phy/omap-phy.txt
+++ b/Documentation/devicetree/bindings/phy/omap-phy.txt
@@ -47,8 +47,7 @@ usb2phy at 4a0ad080 {
 OMAP PIPE3 PHY
 
 Required properties:
- - compatible: Should be "ti,omap-usb3", "ti,omap-pipe3", "ti,omap-sata"
-   or "ti,omap-pcie"
+ - compatible: Should be "ti,phy-pipe3-usb3" or "ti,phy-pipe3-sata"
  - reg : Address and length of the register set for the device.
  - reg-names: The names of the register addresses corresponding to the registers
    filled in "reg".
diff --git a/drivers/phy/phy-omap-pipe3.c b/drivers/phy/phy-omap-pipe3.c
index 19d1664..67eeaeb 100644
--- a/drivers/phy/phy-omap-pipe3.c
+++ b/drivers/phy/phy-omap-pipe3.c
@@ -219,17 +219,13 @@ static struct phy_ops ops = {
 #ifdef CONFIG_OF
 static const struct of_device_id omap_pipe3_id_table[] = {
 	{
-		.compatible = "ti,omap-pipe3",
+		.compatible = "ti,phy-pipe3-usb3",
 		.data = dpll_map_usb,
 	},
 	{
-		.compatible = "ti,omap-sata",
+		.compatible = "ti,phy-pipe3-sata",
 		.data = dpll_map_sata,
 	},
-	{
-		.compatible = "ti,omap-usb3",
-		.data = dpll_map_usb,
-	},
 	{},
 };
 MODULE_DEVICE_TABLE(of, omap_pipe3_id_table);
-- 
1.7.4.1