[PATCH 2/2] arm: zynq: Enable arm_global_timer

[Sören Brinkmann]

On Sun, Sep 15, 2013 at 01:40:36PM +0100, Grant Likely wrote:
> On Thu, 12 Sep 2013 09:50:40 -0700, Soren Brinkmann <soren.brinkmann at xilinx.com> wrote:
> > Zynq is based on an ARM Cortex-A9 MPCore, which features the
> > arm_global_timer in its SCU. Therefore enable the timer for Zynq.
> > 
> > Signed-off-by: Soren Brinkmann <soren.brinkmann at xilinx.com>
> > ---
> >  arch/arm/boot/dts/zynq-7000.dtsi | 8 ++++++++
> >  arch/arm/mach-zynq/Kconfig       | 1 +
> >  2 files changed, 9 insertions(+)
> > 
> > diff --git a/arch/arm/boot/dts/zynq-7000.dtsi b/arch/arm/boot/dts/zynq-7000.dtsi
> > index e32b92b..eaacb39 100644
> > --- a/arch/arm/boot/dts/zynq-7000.dtsi
> > +++ b/arch/arm/boot/dts/zynq-7000.dtsi
> > @@ -92,6 +92,14 @@
> >  			};
> >  		};
> >  
> > +		global_timer: global_timer at f8f00200 {
> 
> Nit: node names and property names use '-' not '_'. Plus the generic
> names principle suggests the node should be names 'timer' not
> 'global_timer'. The following would be fine:
That is really good to know. When I wrote this line, I read through a
couple of other dtses and was unable to identify a consistent system
behind node/label names.

> 
> 		global_timer: timer at f8f00200 {
All right, I'll change it to this.

	
	Thanks,
	Sören