[PATCH 188/228] cpufreq: davinci: remove calls to cpufreq_notify_transition()

Viresh Kumar viresh.kumar at linaro.org
Fri Sep 13 09:02:14 EDT 2013


Most of the drivers do following in their ->target_index() routines:

	struct cpufreq_freqs freqs;
	freqs.old = old freq...
	freqs.new = new freq...

	cpufreq_notify_transition(policy, &freqs, CPUFREQ_PRECHANGE);

	/* Change rate here */

	cpufreq_notify_transition(policy, &freqs, CPUFREQ_POSTCHANGE);

This is replicated over all cpufreq drivers today and there doesn't exists a
good enough reason why this shouldn't be moved to cpufreq core instead.

Earlier patches have added support in cpufreq core to do cpufreq notification on
frequency change, this one removes it from this driver.

Some related minor cleanups are also done along with it.

Cc: Sekhar Nori <nsekhar at ti.com>
Signed-off-by: Viresh Kumar <viresh.kumar at linaro.org>
---
 drivers/cpufreq/davinci-cpufreq.c | 30 ++++++++++--------------------
 1 file changed, 10 insertions(+), 20 deletions(-)

diff --git a/drivers/cpufreq/davinci-cpufreq.c b/drivers/cpufreq/davinci-cpufreq.c
index 1f5d8a5..5e8a854 100644
--- a/drivers/cpufreq/davinci-cpufreq.c
+++ b/drivers/cpufreq/davinci-cpufreq.c
@@ -68,46 +68,36 @@ static unsigned int davinci_getspeed(unsigned int cpu)
 
 static int davinci_target(struct cpufreq_policy *policy, unsigned int idx)
 {
-	int ret = 0;
-	struct cpufreq_freqs freqs;
 	struct davinci_cpufreq_config *pdata = cpufreq.dev->platform_data;
 	struct clk *armclk = cpufreq.armclk;
+	unsigned int old_freq, new_freq;
+	int ret = 0;
 
-	freqs.old = davinci_getspeed(0);
-	freqs.new = pdata->freq_table[idx].frequency;
-
-	dev_dbg(cpufreq.dev, "transition: %u --> %u\n", freqs.old, freqs.new);
-
-	cpufreq_notify_transition(policy, &freqs, CPUFREQ_PRECHANGE);
+	old_freq = davinci_getspeed(0);
+	new_freq = pdata->freq_table[idx].frequency;
 
 	/* if moving to higher frequency, up the voltage beforehand */
-	if (pdata->set_voltage && freqs.new > freqs.old) {
+	if (pdata->set_voltage && new_freq > old_freq) {
 		ret = pdata->set_voltage(idx);
 		if (ret)
-			goto out;
+			return ret;
 	}
 
 	ret = clk_set_rate(armclk, idx);
 	if (ret)
-		goto out;
+		return ret;
 
 	if (cpufreq.asyncclk) {
 		ret = clk_set_rate(cpufreq.asyncclk, cpufreq.asyncrate);
 		if (ret)
-			goto out;
+			return ret;
 	}
 
 	/* if moving to lower freq, lower the voltage after lowering freq */
-	if (pdata->set_voltage && freqs.new < freqs.old)
+	if (pdata->set_voltage && new_freq < old_freq)
 		pdata->set_voltage(idx);
 
-out:
-	if (ret)
-		freqs.new = freqs.old;
-
-	cpufreq_notify_transition(policy, &freqs, CPUFREQ_POSTCHANGE);
-
-	return ret;
+	return 0;
 }
 
 static int davinci_cpu_init(struct cpufreq_policy *policy)
-- 
1.7.12.rc2.18.g61b472e




More information about the linux-arm-kernel mailing list