[PATCH 060/228] cpufreq: cpu0: Use generic cpufreq routines

[Viresh Kumar]

Most of the CPUFreq drivers do similar things in .exit() and .verify() routines
and .attr. So its better if we have generic routines for them which can be used
by cpufreq drivers then.

This patch uses these generic routines for this driver.

Acked-by: Shawn Guo <shawn.guo at linaro.org>
Signed-off-by: Viresh Kumar <viresh.kumar at linaro.org>
---
 drivers/cpufreq/cpufreq-cpu0.c | 23 +++--------------------
 1 file changed, 3 insertions(+), 20 deletions(-)

diff --git a/drivers/cpufreq/cpufreq-cpu0.c b/drivers/cpufreq/cpufreq-cpu0.c
index ce4fa47..2847ae6 100644
--- a/drivers/cpufreq/cpufreq-cpu0.c
+++ b/drivers/cpufreq/cpufreq-cpu0.c
@@ -29,11 +29,6 @@ static struct clk *cpu_clk;
 static struct regulator *cpu_reg;
 static struct cpufreq_frequency_table *freq_table;
 
-static int cpu0_verify_speed(struct cpufreq_policy *policy)
-{
-	return cpufreq_frequency_table_verify(policy, freq_table);
-}
-
 static unsigned int cpu0_get_speed(unsigned int cpu)
 {
 	return clk_get_rate(cpu_clk) / 1000;
@@ -147,27 +142,15 @@ static int cpu0_cpufreq_init(struct cpufreq_policy *policy)
 	return 0;
 }
 
-static int cpu0_cpufreq_exit(struct cpufreq_policy *policy)
-{
-	cpufreq_frequency_table_put_attr(policy->cpu);
-
-	return 0;
-}
-
-static struct freq_attr *cpu0_cpufreq_attr[] = {
-	&cpufreq_freq_attr_scaling_available_freqs,
-	NULL,
-};
-
 static struct cpufreq_driver cpu0_cpufreq_driver = {
 	.flags = CPUFREQ_STICKY,
-	.verify = cpu0_verify_speed,
+	.verify = cpufreq_generic_frequency_table_verify,
 	.target = cpu0_set_target,
 	.get = cpu0_get_speed,
 	.init = cpu0_cpufreq_init,
-	.exit = cpu0_cpufreq_exit,
+	.exit = cpufreq_generic_exit,
 	.name = "generic_cpu0",
-	.attr = cpu0_cpufreq_attr,
+	.attr = cpufreq_generic_attr,
 };
 
 static int cpu0_cpufreq_probe(struct platform_device *pdev)
-- 
1.7.12.rc2.18.g61b472e