[PATCH 4/4] ARM: dts: am335x-bone-common: add cpu0 and mmc1 triggers

[Nishanth Menon]

On 09/12/2013 10:42 AM, Koen Kooi wrote:
> This matches the vendor 3.8.x configuration that is shipping with the boards.
> 
> The LED layout is now:
> 
> USR0: heartbeat
> USR1: mmc0 (micro-SD slot)
> USR2: cpu0
> USR3: mmc1 (eMMC)
> 
> The cpu0 triggers was put inbetween the mmc triggers to make is easier to see
nitpick: sinbetween/in between/

> where the disk activity is.
> 
> Signed-off-by: Koen Kooi <koen at dominion.thruhere.net>
> ---
>  arch/arm/boot/dts/am335x-bone-common.dtsi | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/am335x-bone-common.dtsi b/arch/arm/boot/dts/am335x-bone-common.dtsi
> index 80407ff..3057f30 100644
> --- a/arch/arm/boot/dts/am335x-bone-common.dtsi
> +++ b/arch/arm/boot/dts/am335x-bone-common.dtsi
> @@ -203,12 +203,14 @@
>  		led at 4 {
>  			label = "beaglebone:green:usr2";
>  			gpios = <&gpio1 23 GPIO_ACTIVE_HIGH>;
> +			linux,default-trigger = "cpu0";
>  			default-state = "off";
>  		};
>  
>  		led at 5 {
>  			label = "beaglebone:green:usr3";
>  			gpios = <&gpio1 24 GPIO_ACTIVE_HIGH>;
> +			linux,default-trigger = "mmc1";
>  			default-state = "off";
>  		};
>  	};
> 


-- 
Regards,
Nishanth Menon