[PATCH 1/4] arm: bone: dts: add CD for mmc1

[Nishanth Menon]

nitpick minor comment:
$subject: ARM: dts: am335x-bone: add card detect for mmc1

btw, please use V3 in $subject next time. --subject-prefix "PATCH V3"
when generating patch should do the job.

On 09/12/2013 10:42 AM, Koen Kooi wrote:
> From: Alexander Holler <holler at ahsoftware.de>
> 
> This enables the use of MMC cards even when no card was inserted at boot.
> 
> Signed-off-by: Alexander Holler <holler at ahsoftware.de>
> Signed-off-by: Koen Kooi <koen at dominion.thruhere.net>
> ---
> 
> Changes since v2:
> 	None, again a simple repost
> 
> Changes since v1:
> 	None, simple repost
> 
>  arch/arm/boot/dts/am335x-bone-common.dtsi | 14 ++++++++++++++
>  arch/arm/boot/dts/am335x-bone.dts         |  4 ----
>  2 files changed, 14 insertions(+), 4 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/am335x-bone-common.dtsi b/arch/arm/boot/dts/am335x-bone-common.dtsi
> index 2f66ded..ced256c 100644
> --- a/arch/arm/boot/dts/am335x-bone-common.dtsi
> +++ b/arch/arm/boot/dts/am335x-bone-common.dtsi
> @@ -107,6 +107,11 @@
>  				0x14c (PIN_INPUT_PULLDOWN | MUX_MODE7)
>  			>;
>  		};

An EOL here would be nice to separate the nodes.

> +		mmc1_pins: pinmux_mmc1_pins {
> +			pinctrl-single,pins = <
> +				0x160 (PIN_INPUT | MUX_MODE7) /* GPIO0_6 */
> +			>;
> +		};
>  	};
>  
>  	ocp {
> @@ -260,3 +265,12 @@
>  	pinctrl-0 = <&davinci_mdio_default>;
>  	pinctrl-1 = <&davinci_mdio_sleep>;
>  };
> +
> +&mmc1 {
> +	status = "okay";
> +	vmmc-supply = <&ldo3_reg>;
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&mmc1_pins>;
> +	cd-gpios = <&gpio0 6 GPIO_ACTIVE_HIGH>;
> +	cd-inverted;
> +};
> diff --git a/arch/arm/boot/dts/am335x-bone.dts b/arch/arm/boot/dts/am335x-bone.dts
> index d5f43fe..d34469c 100644
> --- a/arch/arm/boot/dts/am335x-bone.dts
> +++ b/arch/arm/boot/dts/am335x-bone.dts
> @@ -16,7 +16,3 @@
>  	regulator-always-on;
>  };
>  
> -&mmc1 {
> -	status = "okay";
> -	vmmc-supply = <&ldo3_reg>;
> -};
> 


-- 
Regards,
Nishanth Menon