[PATCH 0/3] ARM: dts: Enable EDMA, MMC and SPI on AM33XX for v3.13

[Joel Fernandes]

On 09/10/2013 02:39 PM, Koen Kooi wrote:
> 
> Op 10 sep. 2013, om 21:24 heeft Joel Fernandes <joelf at ti.com> het volgende geschreven:
> 
>> Here are last few patches required to add EDMA and MMC/SPI support for AM33xx.
>>
>> Now that all dependent DMA patches and fixes are in linux next or mainline, except
>> for [1] which should go in for 3.12 -rc cycle, it is safe to enable MMC and SPI support
>> and this patch series enables it. These are originally Matt Porter's patches with
>> changes to make it work with recent kernels, addition of irq, memory resources and
>> enable other extra properties.
>>
>> These patches should cleanly apply on master branch after Koen's patch [2] for basic
>> BBB DT support is applied.
>>
>> MMC support is enabled for: Beaglebone, AM335x EVM and EVM-SK boards. MMC support
>> for BBB is intentionally not added due to custom fixes and other patches that are
>> in Koen's tree and which will be separately submitted by him.
> 
> Correct, but your patches for MMC support on BBW are missing the card detect entries to make it hotplug work.

I thought it was determined that this would be submitted by you separately after
rebasing as we discussed [1] and [2].

[1] https://lkml.org/lkml/2013/9/6/183
[2] http://marc.info/?l=linux-omap&m=137879246709612&w=2


Regards,

-Joel