[PATCH 01/38] ARM: ux500: Remove PrimeCell IDs from Nomadik I2C DT nodes

[Lee Jones]

Turns out that they're actually not required and the driver probes just
fine without them. The ID is incorrect at the moment anyway. They actually
currently specify the stn8815.

Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 arch/arm/boot/dts/ste-dbx5x0.dtsi | 5 -----
 1 file changed, 5 deletions(-)

diff --git a/arch/arm/boot/dts/ste-dbx5x0.dtsi b/arch/arm/boot/dts/ste-dbx5x0.dtsi
index 1c1091e..0c1338e 100644
--- a/arch/arm/boot/dts/ste-dbx5x0.dtsi
+++ b/arch/arm/boot/dts/ste-dbx5x0.dtsi
@@ -559,7 +559,6 @@
 			compatible = "stericsson,db8500-i2c", "st,nomadik-i2c", "arm,primecell";
 			reg = <0x80004000 0x1000>;
 			interrupts = <0 21 IRQ_TYPE_LEVEL_HIGH>;
-			arm,primecell-periphid = <0x180024>;
 
 			#address-cells = <1>;
 			#size-cells = <0>;
@@ -572,7 +571,6 @@
 			compatible = "stericsson,db8500-i2c", "st,nomadik-i2c", "arm,primecell";
 			reg = <0x80122000 0x1000>;
 			interrupts = <0 22 IRQ_TYPE_LEVEL_HIGH>;
-			arm,primecell-periphid = <0x180024>;
 
 			#address-cells = <1>;
 			#size-cells = <0>;
@@ -585,7 +583,6 @@
 			compatible = "stericsson,db8500-i2c", "st,nomadik-i2c", "arm,primecell";
 			reg = <0x80128000 0x1000>;
 			interrupts = <0 55 IRQ_TYPE_LEVEL_HIGH>;
-			arm,primecell-periphid = <0x180024>;
 
 			#address-cells = <1>;
 			#size-cells = <0>;
@@ -598,7 +595,6 @@
 			compatible = "stericsson,db8500-i2c", "st,nomadik-i2c", "arm,primecell";
 			reg = <0x80110000 0x1000>;
 			interrupts = <0 12 IRQ_TYPE_LEVEL_HIGH>;
-			arm,primecell-periphid = <0x180024>;
 
 			#address-cells = <1>;
 			#size-cells = <0>;
@@ -611,7 +607,6 @@
 			compatible = "stericsson,db8500-i2c", "st,nomadik-i2c", "arm,primecell";
 			reg = <0x8012a000 0x1000>;
 			interrupts = <0 51 IRQ_TYPE_LEVEL_HIGH>;
-			arm,primecell-periphid = <0x180024>;
 
 			#address-cells = <1>;
 			#size-cells = <0>;
-- 
1.8.1.2