[PATCH v3 09/10] ARM: dts: omap3-beagle-xm: Add USB Host support

[Tony Lindgren]

* Roger Quadros <rogerq at ti.com> [131120 02:33]:
> Nishant,
> 
> On 11/19/2013 11:05 PM, Nishanth Menon wrote:
> > 
> > 
> > On 09/24/2013 03:53 AM, Roger Quadros wrote:
> >> Provide RESET GPIO and Power regulator for the USB PHY,
> >> the USB Host port mode and the PHY device for the controller.
> >> Also provide pin multiplexer information for USB host pins.
> >>
> >> We also relocate omap3_pmx_core pin definations so that they
> >> are close to omap3_pmx_wkup pin definations.
> >>
> >> Signed-off-by: Roger Quadros <rogerq at ti.com>
> >> ---
> > 
> > just using this thread, but a question ->
> > 
> > I am kernel * master                                   dec8e46 Merge
> > tag 'arc-v3.13-rc1-part2' of
> > git://git.kernel.org/pub/scm/linux/kernel/git/vgupta/arc
> > 
> > and I see that VAUX2 which supplies USB_1V8[1] is not enabled -> I did
> > a quick patch and it did seem to work (Usb keyboard, networking, mouse
> > etc on my ehci ports seems to come up good) - any suggestions how we'd
> > like to handle this?
> 
> It worked for me without your patch. It could be that u-boot is enabling
> that regulator for me. I'm on u-boot-v2013.10.
> 
> In any case, your patch seems the right thing to do. We should take it in
> the rc cycle.

Can you guys post a proper fix for this? Meanwhile, I'll mark this
thread as read to shrink my inbox a bit.

Regards,

Tony