[PATCH 3/3] ARM: keystone: defconfig: enable USB host mode support

[WingMan Kwok]

Enable the USB host mode support on TI's Keystone platform.
It also enables the support of usb mass storage, FAT and Ext4
filesystems to test rootfs mount over an USB disk.

Cc: Santosh Shilimkar <santosh.shilimkar at ti.com>
Signed-off-by: WingMan Kwok <w-kwok2 at ti.com>
---
 arch/arm/configs/keystone_defconfig |   20 +++++++++++++++++++-
 1 file changed, 19 insertions(+), 1 deletion(-)

diff --git a/arch/arm/configs/keystone_defconfig b/arch/arm/configs/keystone_defconfig
index 9943e5d..686f612 100644
--- a/arch/arm/configs/keystone_defconfig
+++ b/arch/arm/configs/keystone_defconfig
@@ -115,6 +115,8 @@ CONFIG_MTD_UBI=y
 CONFIG_PROC_DEVICETREE=y
 CONFIG_BLK_DEV_LOOP=y
 CONFIG_EEPROM_AT24=y
+CONFIG_SCSI=y
+CONFIG_BLK_DEV_SD=y
 CONFIG_NETDEVICES=y
 CONFIG_SERIAL_8250=y
 CONFIG_SERIAL_8250_CONSOLE=y
@@ -129,10 +131,24 @@ CONFIG_SPI_DAVINCI=y
 CONFIG_SPI_SPIDEV=y
 # CONFIG_HWMON is not set
 CONFIG_WATCHDOG=y
-# CONFIG_USB_SUPPORT is not set
+CONFIG_USB=y
+CONFIG_USB_DEBUG=y
+CONFIG_USB_ANNOUNCE_NEW_DEVICES=y
+CONFIG_USB_MON=y
+CONFIG_USB_XHCI_HCD=y
+CONFIG_USB_STORAGE=y
+CONFIG_USB_DWC3=y
+CONFIG_USB_DWC3_DEBUG=y
+CONFIG_USB_DWC3_VERBOSE=y
+CONFIG_NOP_USB_XCEIV=y
 CONFIG_DMADEVICES=y
 CONFIG_COMMON_CLK_DEBUG=y
 CONFIG_MEMORY=y
+CONFIG_EXT4_FS=y
+CONFIG_EXT4_FS_POSIX_ACL=y
+CONFIG_MSDOS_FS=y
+CONFIG_VFAT_FS=y
+CONFIG_NTFS_FS=y
 CONFIG_TMPFS=y
 CONFIG_JFFS2_FS=y
 CONFIG_JFFS2_FS_WBUF_VERIFY=y
@@ -144,6 +160,8 @@ CONFIG_ROOT_NFS=y
 CONFIG_NFSD=y
 CONFIG_NFSD_V3=y
 CONFIG_NFSD_V3_ACL=y
+CONFIG_NLS_CODEPAGE_437=y
+CONFIG_NLS_ISO8859_1=y
 CONFIG_PRINTK_TIME=y
 CONFIG_DEBUG_SHIRQ=y
 CONFIG_DEBUG_INFO=y
-- 
1.7.9.5