[PATCHv2] ARM: mvebu: Add Netgear ReadyNAS 2120 board

[Jason Cooper]

On Tue, Nov 12, 2013 at 08:46:48PM +0100, Arnaud Ebalard wrote:
> 
> All hardware parts of the (mv78230 Armada XP based) NETGEAR ReadyNAS
> 2120 are supported by mainline kernel (USB 3.0 and eSATA rear ports,
> USB 2.0 front port, Gigabit controller and PHYs for the two rear ports,
> serial port, LEDs, Buttons, 88SE9170 SATA controllers, three G762 fan
> controllers, G751 temperature sensor) except for:
> 
>  - the Intersil ISL12057 I2C RTC Chip,
>  - the Armada NAND controller.
> 
> Support for both of those is currently work in progress and does not
> prevent boot.
> 
> Acked-by: Sebastian Hesselbarth <sebastian.hesselbarth at gmail.com>
> Signed-off-by: Arnaud Ebalard <arno at natisbad.org>
> ---
...
>  arch/arm/boot/dts/Makefile                     |   1 +
>  arch/arm/boot/dts/armada-xp-netgear-rn2120.dts | 288 +++++++++++++++++++++++++
>  2 files changed, 289 insertions(+)
>  create mode 100644 arch/arm/boot/dts/armada-xp-netgear-rn2120.dts

Applied to mvebu/dt

thx,

Jason.