[PATCH 2/2] memory: ti-aemif: add bindings for AEMIF driver

Jean-Christophe PLAGNIOL-VILLARD plagnioj at jcrosoft.com
Wed Nov 20 13:21:02 EST 2013


> +				the chip select signal.
> +				Minimum value is 1 (0 treated as 1).
> +
> +- ti,cs-wsetup:		write setup width, ns
> +				Time between the beginning of a memory cycle
> +				and the activation of write strobe.
> +				Minimum value is 1 (0 treated as 1).
> +
> +- ti,cs-wstrobe:	write strobe width, ns
> +				Time between the activation and deactivation of
> +				the write strobe.
> +				Minimum value is 1 (0 treated as 1).
> +
> +- ti,cs-whold:		write hold width, ns
> +				Time between the deactivation of the write
> +				strobe and the end of the cycle (which may be
> +				either an address change or the deactivation of
> +				the chip select signal.
> +				Minimum value is 1 (0 treated as 1).
> +
> +If any of the above parameters are absent, current parameter value will be taken
> +from the corresponding HW reg.
> +
> +The name for cs node must be in format csN, where N is the cs number.

this is wired we should use reg instead to represent the cs as done for SPI
or a an other property

Best Regards,
J.



More information about the linux-arm-kernel mailing list