[RESEND PATCH 1/6] ahci: imx: Explicitly clear IMX6Q_GPR13_SATA_MPLL_CLK_EN

[Tejun Heo]

On Wed, Nov 20, 2013 at 11:27:22AM +0100, Marek Vasut wrote:
> We must clear this IMX6Q_GPR13_SATA_MPLL_CLK_EN bit on i.MX6Q, otherwise
> Linux will fail to find the attached drive on some boards.
> 
> This entire fix was:
> Reported-by: Eric Nelson <eric.nelson at boundarydevices.com>
> 
> Signed-off-by: Marek Vasut <marex at denx.de>
> Cc: Shawn Guo <shawn.guo at linaro.org>
> Cc: Richard Zhu <r65037 at freescale.com>
> Cc: Tejun Heo <tj at kernel.org>
> Cc: Linux-IDE <linux-ide at vger.kernel.org>
> ---
>  drivers/ata/ahci_imx.c | 1 +
>  1 file changed, 1 insertion(+)
> 
> RESEND: Fix the Cc here.
> 
> diff --git a/drivers/ata/ahci_imx.c b/drivers/ata/ahci_imx.c
> index ae2d73f..478921b 100644
> --- a/drivers/ata/ahci_imx.c
> +++ b/drivers/ata/ahci_imx.c
> @@ -125,6 +125,7 @@ static int imx6q_sata_init(struct device *dev, void __iomem *mmio)
>  			| IMX6Q_GPR13_SATA_TX_BOOST_MASK
>  			| IMX6Q_GPR13_SATA_TX_LVL_MASK
>  			| IMX6Q_GPR13_SATA_TX_EDGE_RATE
> +			| IMX6Q_GPR13_SATA_MPLL_CLK_EN
>  			, IMX6Q_GPR13_SATA_RX_EQ_VAL_3_0_DB
>  			| IMX6Q_GPR13_SATA_RX_LOS_LVL_SATA2M
>  			| IMX6Q_GPR13_SATA_RX_DPLL_MODE_2P_4F

Not your fault but when things stretch over multiples lines, the
convention is to put the operators and commas at the end of each line
not the other way around.  I'd appreciate if you add a trivial patch
to update that too.

Thanks.

-- 
tejun