[PATCH 11/11] OMAPDSS: DPI: use VPLL2 regulator if VDDS_DSI is not found
sre at ring0.de
Sat Nov 16 19:26:00 EST 2013
On Sat, Nov 16, 2013 at 06:28:00PM +0100, Javier Martinez Canillas wrote:
> > The hack, as being sent by Javier, will result in the wrong
> > regulator being used on the Nokia N900, which is using vaux1.
> > It must depend on the machine.
> I see, so this hack is not generic enough to be usable for all OMAP3 boards so I
> think is better to just add the hack on the DTS.
> I was more found about adding a hack on dpi.c since the DTB is an stable ABI
> while the dpi.c implementation is not.
I agree with this. My suggestion would be to get the vdds_dsi regulator name
from platform data. This way each board can setup its own quirk until omapdss
> But I guess is not that bad to change the DTS later once DSS DT
> bindings are added to mainline.
As far as I know DT bindings are supposed to be as stable as
> > At the same time the N900 device tree file uses V28 as
> > regulator-name for vaux1 (which is the same one as legacy boot
> > used). Nothing depends on this, but I don't think it's a
> > good idea to use this property. Apparently it does not work
> > if multiple drivers need the same regulator under different
> > names.
> > -- Sebastian
> So, what do you think about the following patch instead?
For Nokia N900 vaux1 is also used for si4713 radio chip, lis3lv02d
accelerometer and battery cover sensor, so I don't like this hack.
If vppl2 is only used for omapdss.dsi on IGEP boards it might be
sensible to label it, though? So it might be ok there.
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 836 bytes
Desc: Digital signature
More information about the linux-arm-kernel