[PATCH 10/12] mtd: nand: davinci: don't set timings if AEMIF is used

Sekhar Nori nsekhar at ti.com
Thu Nov 14 05:53:45 EST 2013

On Wednesday 13 November 2013 07:44 PM, Santosh Shilimkar wrote:
> On Wednesday 13 November 2013 12:02 AM, Sekhar Nori wrote:
>> On Monday 11 November 2013 10:40 PM, Khoronzhuk, Ivan wrote:
>>> If Davinci AEMIF is used we don't need to set timings and bus width.
>>> It is done by AEMIF driver (drivers/memory/davinci-aemfi.c).
>>> Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk at ti.com>
>>> ---
>>>  drivers/mtd/nand/davinci_nand.c |   22 +++++++++++++++-------
>>>  1 file changed, 15 insertions(+), 7 deletions(-)
>>> diff --git a/drivers/mtd/nand/davinci_nand.c b/drivers/mtd/nand/davinci_nand.c
>>> index 4705214..879e915 100644
>>> --- a/drivers/mtd/nand/davinci_nand.c
>>> +++ b/drivers/mtd/nand/davinci_nand.c
>>> @@ -742,27 +742,35 @@ static int __init nand_davinci_probe(struct platform_device *pdev)
>>>                 goto err_clk_enable;
>>>         }
>> This is a hack! Just because AEMIF driver is enabled, it does not
>> guarantee that the timings have been setup by it. Instead of configuring
>> timings in two drivers, why not just convert everyone over to use the
>> new driver. Dont worry about breaking old platforms, I will help test
>> and ack them.
> How about you take a stab at and convert the DaVinci code over to make
> use of new driver. We are trying to re-use as much as possible from the
> common drivers and also making an option so that the DaVinci arch can
> move over to these drivers if they want to.

Sure I could.


The AEMIF driver does not use platfrom_data currently. Is that something
you can add or you want me to take a stab at that as well?


More information about the linux-arm-kernel mailing list