[PATCH 10/12] mtd: nand: davinci: don't set timings if AEMIF is used

[Santosh Shilimkar]

On Monday 11 November 2013 12:10 PM, Khoronzhuk, Ivan wrote:
> If Davinci AEMIF is used we don't need to set timings and bus width.
> It is done by AEMIF driver (drivers/memory/davinci-aemfi.c).
> 
> Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk at ti.com>
> ---
>  drivers/mtd/nand/davinci_nand.c |   22 +++++++++++++++-------
>  1 file changed, 15 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/mtd/nand/davinci_nand.c b/drivers/mtd/nand/davinci_nand.c
> index 4705214..879e915 100644
> --- a/drivers/mtd/nand/davinci_nand.c
> +++ b/drivers/mtd/nand/davinci_nand.c
> @@ -742,27 +742,35 @@ static int __init nand_davinci_probe(struct platform_device *pdev)
>                 goto err_clk_enable;
>         }
> 
> +#if !IS_ENABLED(CONFIG_TI_DAVINCI_AEMIF)
>
Instead above #if, just use a variable.
	bool aemif = IS_ENABLED(CONFIG_TI_DAVINCI_AEMIF) and then skip
the below code. #if block in the middle of the code looks ugly.

Other than that patch looks fine to me.

Regards,
Santosh