Physical memory start contraints in the Linux kernel (Was: Re: Xen osstest on Calxeda midway progress (Was: Re: [Xen-devel] [xen-unstable test] 21486: tolerable FAIL - PUSHED))
Julien Grall
julien.grall at linaro.org
Tue Nov 12 09:35:10 EST 2013
On 11/12/2013 01:37 PM, Arnd Bergmann wrote:
> On Tuesday 12 November 2013, Stefano Stabellini wrote:
>
> Hi Stefano,
>
> I haven't given it too much thought, but here is what I believe should
> be done:
>
>> The question for you, as arm-soc maintainers, is: do you think this
>> should work and if we find any issues we should just fix them or report
>> them as bugs?
>
> Modifying the DT to mark anything as "reserved" or absent that Dom0
> should or can not touch sounds like the correct way to do this. Whether
> this needs to be done by modifying the reg property of the device node
> or through a different method I can't tell.
>
> If you find bugs in the kernel that prevent this from working, but it
> works fine for everyone else, it's up to you to provide a bug-fix,
> which would most likely be up to Russell to apply.
>
>> Is this entirely going away with multiplatform kernels so we shouldn't
>> worry about it?
>
> Multiplatform kernels are by definition relocatable using
> CONFIG_ARM_PATCH_PHYS_VIRT, within some limitations such as the
> granularity of the mapping. You certainly can't move the start of memory
> to an address of smaller than 2MB (hugepage) alignment, but you might
> need something larger than that.
During some debugging on the Arndale and Midway, I found another
constraint with CONFIG_ARM_PATCH_PHYS_VIRT.
I have noticed that all the kernel physical addresses must be lower than
the corresponding virtual addresses. So the delta offset compute in
__fixup_pv_table (arch/arm/kernel/head.S) must always be negative.
If this assertion is not validated, when the kernel will browse the
memory bank (sanity_check_info in arch/arm/mm/mmu.c), __phys(...) will
compute a wrong address and will result to consider all memory bank as
highmem.
After digging in the code, it seems it's due to some optimization during
opcode fixup in __fixup_a_pvtable. Is it a wanted constraint?
>> Or is this a lost fight and should we find a workaround (see below if we
>> are curious) to make the start of memory look the same?
>
> I don't see what hack you are referring to, can you elaborate?
>
> My feeling is that we should maintain the requirement that that it must be
> possible to enable Dom0 support on any virtualisation-capable platform
> without breaking other platforms or causing an unreasonable run-time
> overhead.
>
> BTW, does Dom0 require an LPAE-enabled kernel or can it be a regular
> non-LPAE ARMv6/v7 multiplatform build?
It can be both.
Cheers,
--
Julien Grall
More information about the linux-arm-kernel
mailing list