[RFCv2][PATCHv5 0/4] Add Freescale FTM PWM driver.

[Li Xiubo]

Hi Thierry,

The document binding patch of this patch series has been acked.
And other patches have been acked before.

Should I send a V6 patch series ?

Thanks very much.


--


> Subject: [RFCv2][PATCHv5 0/4] Add Freescale FTM PWM driver.
> 
> Hello,
> 
> This patch series is the Freescale FTM PWM implementation. And there are
> 8 channels most supported by the FTM PWM. This implementation is only
> compatible with device tree definition.
> 
> This patch series is based on linux-next and has been tested on Vybrid
> VF610 Tower board using device tree.
> 
> 
> 
> Changes in RFCv2 of PATVHv5:
> - Remove "fsl,pwm-counter-clk"(all the four patches are modified).
> 
> Changes in v5:
> - Remove active/idle pinctrl stuff.
> 
> Changes in v4:
> - Check for the result and return an error for devm_kzalloc().
> - Move pinmux setting from the SoC file to the board specific file.
> - Revise the written mistake of 'ret |= FTMSC_CLKEXT;' --> 'reg |=
> FTMSC_CLKEXT;'.
> 
> 
> Changes in v3:
> - Remove "availabe" field.
> - Remove "fsl,pwm-avaliable-chs" property.
> - ...
> 
> Changes in v2:
> - Remove PWM CPWM/EPWM feature and sysfs.
> - Remove some redundant code.
> - Revise some code for more readable.
> - Remove "fsl,pwm-clk-ps", "fsl,pwm-number", "fsl,pwm-channels",etc.
> - Add "fsl,pwm-avaliable-chs", "fsl,pwm-counter-clk", etc.
> - Support 8 channels default in dtsi file.
> - Add counter clock source selection.
> - Rename some function name, macro name, etc.
> - Use PWM's and OF's existing function interfaces.
> - Split clk_unprepare_enable to clk_unprepare and clk_enable,etc.
> - ...
> 
> Added in v1:
> - Add Freescale FTM PWM driver support.
> - Add Freescale FTM PWM node for VF610.
> - Enable Enables FTM PWM device for Vybrid VF610 TOWER.
> - Add device tree bindings for Freescale.