[PATCH v3 27/28] ARM: mvebu: Enable NAND controller in Armada 370 Mirabox

[Ezequiel Garcia]

The Armada 370 Mirabox has a NAND flash, so enable it in the devicetree
and add the partitions as prepared in the factory images.

In order to skip the driver's custom device detection and use only
ONFI detection, the "marvell,keep-config" parameter is used.
This is needed because we have no support for setting the timings parameters yet.

Signed-off-by: Ezequiel Garcia <ezequiel.garcia at free-electrons.com>
---
 arch/arm/boot/dts/armada-370-mirabox.dts | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/arch/arm/boot/dts/armada-370-mirabox.dts b/arch/arm/boot/dts/armada-370-mirabox.dts
index 2471d9d..1e73017 100644
--- a/arch/arm/boot/dts/armada-370-mirabox.dts
+++ b/arch/arm/boot/dts/armada-370-mirabox.dts
@@ -139,6 +139,27 @@
 					reg = <0x25>;
 				};
 			};
+
+			nand at d0000 {
+				status = "okay";
+				num-cs = <1>;
+				marvell,nand-keep-config;
+				marvell,nand-enable-arbiter;
+				nand-on-flash-bbt;
+
+				partition at 0 {
+					label = "U-Boot";
+					reg = <0 0x400000>;
+				};
+				partition at 400000 {
+					label = "Linux";
+					reg = <0x400000 0x400000>;
+				};
+				partition at 800000 {
+					label = "Filesystem";
+					reg = <0x800000 0x3f800000>;
+				};
+			};
 		};
 	};
 };
-- 
1.8.1.5