[PATCH v3 00/28] Armada 370/XP NAND support

[Ezequiel Garcia]

Behold the Armada 370/XP SoCs v3 patchset!

This time the details about the controller have been added to
Documentation/mtd/nand/pxa3xx-nand.txt, so I'd appreciate if you could review
the docs as well.

It's worth noting that the *only* previously remaining issue (the bad block
factory initial detection) has been addressed by this recent patch:

  http://patchwork.ozlabs.org/patch/288482/

If the change is accepted,  I'll send a simple follow-up patch to make use
of the new option.

In other words, this series is now _complete_, and so I've switched to
"get-feedback-and-resubmit" mode :-)

Patches 1-4, adding the clock infrastructure have already been merged
and will be dropped once this series can be based on v3.13-rc1.
I'm including them just for completeness.

Based in l2-mtd's master branch. Also, I've pushed a branch to our github
in case anyone wants to test it:

  https://github.com/MISL-EBU-System-SW/mainline-public/tree/l2-mtd/upstream-nand-v3

Thanks!

* Changes from v2 (some minor fixes as per Huang's good feedback)

  * Add some more details to the commit log in patch
    "mtd: nand: pxa3xx: Early variant detection"

  * Add an empty line between variable declaration and function body
    in patch "mtd: nand: pxa3xx: Use chip->cmdfunc instead of the internal".

  * Fix a build break caused by incomplete variable replacement:
    "mtd: nand: pxa3xx: Replace host->page_size by mtd->writesize"

* Changes from v1

Aside from several changes based in Brian's feedback, the main changes
from v1 are:

  * The controller's clock source is now fully modeled, see patche 1 to 4.
    Of course, none of those patches should be taken through the mtd
    subsystem, but I'm adding them here for completeness.

  * The chip's cmdfunc() is now independently implemented in each SoC variant.
    The rationale behind this decision is that 'chunked' I/O is the only tested
    mode on the Armada370 variant, while the old 'vanilla' I/O is the only
    tested mode on the PXA variant.

    So it's safer to have an implementation for each variant.

  * Added support for BCH-8, in other words: 8-bits of correction in a 512-byte
    region. This is obtained by using a data chunk size of 1024B, thus doubling
    the ECC BCH strength, as per this ECC engine mechanism.

  * The ECC layout in use, which must be set according to the page size and
    desired ECC strength is now strictly chosen to match only the tested
    combinations.

Ezequiel Garcia (28):
  clk: mvebu: Add Core Divider clock
  ARM: mvebu: Add Core Divider clock device-tree binding
  ARM: mvebu: Add a 2 GHz fixed-clock Armada 370/XP
  ARM: mvebu: Add the core-divider clock to Armada 370/XP
  mtd: nand: pxa3xx: Make config menu show supported platforms
  mtd: nand: pxa3xx: Prevent sub-page writes
  mtd: nand: pxa3xx: Early variant detection
  mtd: nand: pxa3xx: Use chip->cmdfunc instead of the internal
  mtd: nand: pxa3xx: Split FIFO size from to-be-read FIFO count
  mtd: nand: pxa3xx: Replace host->page_size by mtd->writesize
  mtd: nand: pxa3xx: Add a nice comment to pxa3xx_set_datasize()
  mtd: nand: pxa3xx: Use a completion to signal device ready
  mtd: nand: pxa3xx: Add bad block handling
  mtd: nand: pxa3xx: Add driver-specific ECC BCH support
  mtd: nand: pxa3xx: Clear cmd buffer #3 (NDCB3) on command start
  mtd: nand: pxa3xx: Add helper function to set page address
  mtd: nand: pxa3xx: Remove READ0 switch/case falltrough
  mtd: nand: pxa3xx: Split prepare_command_pool() in two stages
  mtd: nand: pxa3xx: Move the data buffer clean to
    prepare_start_command()
  mtd: nand: pxa3xx: Fix SEQIN column address set
  mtd: nand: pxa3xx: Add a read/write buffers markers
  mtd: nand: pxa3xx: Introduce multiple page I/O support
  mtd: nand: pxa3xx: Add multiple chunk write support
  mtd: nand: pxa3xx: Add ECC BCH correctable errors detection
  ARM: mvebu: Add support for NAND controller in Armada 370/XP
  ARM: mvebu: Enable NAND controller in Armada XP GP board
  ARM: mvebu: Enable NAND controller in Armada 370 Mirabox
  mtd: nand: pxa3xx: Add documentation about the controller

 .../bindings/clock/mvebu-corediv-clock.txt         |  19 +
 Documentation/mtd/nand/pxa3xx-nand.txt             | 101 +++
 arch/arm/boot/dts/armada-370-mirabox.dts           |  21 +
 arch/arm/boot/dts/armada-370-xp.dtsi               |  26 +
 arch/arm/boot/dts/armada-xp-gp.dts                 |   8 +
 drivers/clk/mvebu/Kconfig                          |   5 +
 drivers/clk/mvebu/Makefile                         |   1 +
 drivers/clk/mvebu/clk-corediv.c                    | 223 +++++++
 drivers/mtd/nand/Kconfig                           |   4 +-
 drivers/mtd/nand/pxa3xx_nand.c                     | 683 ++++++++++++++++-----
 include/linux/platform_data/mtd-nand-pxa3xx.h      |   3 +
 11 files changed, 955 insertions(+), 139 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/clock/mvebu-corediv-clock.txt
 create mode 100644 Documentation/mtd/nand/pxa3xx-nand.txt
 create mode 100644 drivers/clk/mvebu/clk-corediv.c

-- 
1.8.1.5