[RFT][PATCH 1/2] clk: wm831x: Fix update wrong register for enable/disable FLL

[Mike Turquette]

Quoting Axel Lin (2013-05-01 08:31:01)
> According to the datasheet, FLL Enable is controlled by
> R16530 (4092h) FLL Control1
>         BIT 0: FLL Enable
>                 0 = Disable
>                 1 = Enable
> 
> Thus the code should update WM831X_FLL_CONTROL_1 register rather than
> WM831X_FLL_CONTROL_2 register.
> 
> Also fixes a trivial typo in dev_crit message.
> 
> Signed-off-by: Axel Lin <axel.lin at ingics.com>

Pulled both into clk-next.

Thanks,
Mike

> ---
>  drivers/clk/clk-wm831x.c | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/clk/clk-wm831x.c b/drivers/clk/clk-wm831x.c
> index 16ed068..4bdf0b0 100644
> --- a/drivers/clk/clk-wm831x.c
> +++ b/drivers/clk/clk-wm831x.c
> @@ -97,7 +97,7 @@ static int wm831x_fll_prepare(struct clk_hw *hw)
>         struct wm831x *wm831x = clkdata->wm831x;
>         int ret;
>  
> -       ret = wm831x_set_bits(wm831x, WM831X_FLL_CONTROL_2,
> +       ret = wm831x_set_bits(wm831x, WM831X_FLL_CONTROL_1,
>                               WM831X_FLL_ENA, WM831X_FLL_ENA);
>         if (ret != 0)
>                 dev_crit(wm831x->dev, "Failed to enable FLL: %d\n", ret);
> @@ -114,9 +114,9 @@ static void wm831x_fll_unprepare(struct clk_hw *hw)
>         struct wm831x *wm831x = clkdata->wm831x;
>         int ret;
>  
> -       ret = wm831x_set_bits(wm831x, WM831X_FLL_CONTROL_2, WM831X_FLL_ENA, 0);
> +       ret = wm831x_set_bits(wm831x, WM831X_FLL_CONTROL_1, WM831X_FLL_ENA, 0);
>         if (ret != 0)
> -               dev_crit(wm831x->dev, "Failed to disaable FLL: %d\n", ret);
> +               dev_crit(wm831x->dev, "Failed to disable FLL: %d\n", ret);
>  }
>  
>  static unsigned long wm831x_fll_recalc_rate(struct clk_hw *hw,
> -- 
> 1.8.1.2