[PATCH] ARM: DTS: OMAP4: Panda/SDP: twl6030: fix mux for IRQ pin and msecure line

[Kevin Hilman]

Nishanth Menon <nm at ti.com> writes:

> On Fri, May 24, 2013 at 5:15 PM, Kevin Hilman <khilman at linaro.org> wrote:
>> Kevin Hilman <khilman at linaro.org> writes:
>>
>>> Nishanth Menon <nm at ti.com> writes:
>>
>> [...]
>>
>>>> Actually 2 things:
>>>>
>>>> a) patch seems to do the wrong thing for 4460 - 0x18 offset should
>>>> have been used instead of 0x14 which is correct for 4430?
>>>
>>> I see, thanks.  I'll double check the TRMs.
>>>
>>>> b) yes, I understand,  the current settings we did worked, but the
>>>> mode(0) we are setting to is real weird - we are setting it up for
>>>> clk0 out - I cant even think why it is even working in the first place
>>>> :( - is it because we are pumping out sysclkout and as a result we are
>>>> lucky that msecure is being sampled at the right point by twl6030
>>>> allowing rtc access? either way, IMHO, the configuration is wrong.
>>>
>>> Ah, yes.  Mode zero is definitely wrong.   When I did the original patch
>>> for legacy mode, I just duplicated the settings u-boot was using.  Guess
>>> it's a fluke that it works.
>>
>> Actually, for legacy mode, it's set correctly in mode 2.  This line:
>>
>>         omap_mux_init_signal("fref_clk0_out.sys_drm_msecure", OMAP_PIN_OUTPUT);
>>
>> does the right thing based on the signal name.    But for DT boot, I
>> defintely screwed it up by setting it to mode (and putting it in the
>> wrong padconf section.)
>>
>> Also, are you *really* sure about the offset difference between 4430 and
>> 4460 here?  I don't have access to NDA docs anymore, so I cannot double
>> check this.
>>
>> What I do know is that the legacy code is using 0x54 for both, and if I
>> simply comment out that 'sys_drm_msecure' line above, RTC wake stops
>> working (legacy boot) on both 4430 and 4460, so that seems like pretty
>> stront evidence that it's the same offset on both.
> Schematics are public for PandaBoard ES and PandaBoard - as you can
> see from that the registers connected are definitely different.

What I see from both schematics is that SYS_DRM_MSECURE is available on
a few different pads, but on both 4430 and 4460, one of the places is in
mode 2 of FREF_CLK0_OUT, which is at offset 0x54 on both SoCs.

Based on that reading, and the fact that not correctly muxing that pad
to mode 2 on *both* 4430 and 4460 makes the RTC work, I'm rather
convinced that the offset should be the same for 4430 and 4460.

What am I missing?

Kevin