[PATCH] ASoC: Add support for BCM2708

[Florian Meier]

2013/5/22 Lars-Peter Clausen <lars at metafoo.de>
>
> On 05/22/2013 04:10 PM, Florian Meier wrote:
> [...]
> > diff --git a/sound/soc/bcm2708/bcm2708-i2s.c b/sound/soc/bcm2708/bcm2708-i2s.c
> > new file mode 100644
> > index 0000000..a8e995f
> > --- /dev/null
> > +++ b/sound/soc/bcm2708/bcm2708-i2s.c
> > @@ -0,0 +1,964 @@
> [...]
> > +static int bcm2708_i2s_startup(struct snd_pcm_substream *substream,
> > +                            struct snd_soc_dai *dai)
> > +{
> > +     struct bcm2708_i2s_dev *dev = snd_soc_dai_get_drvdata(dai);
> > +
> > [...]
> > +             } else {
> > +                     snd_pcm_hw_constraint_minmax(substream->runtime,
> > +                                     SNDRV_PCM_HW_PARAM_RATE,
> > +                                     first_runtime->rate,
> > +                                     first_runtime->rate);
> > +             }
>
> Setting the symmetric_rates lets the core take care of setting the proper
> constraints on the rate. It probably makes sense to also add a
> symmetric_formats since this isn't the only driver that has the requirement
> that the formats for playback and capture match.


You are right! I forgot to remove this after I found the symmetric_rates flag.
For symmetric_formats I will have a closer look into the ALSA sources.



> [...]
> > diff --git a/sound/soc/bcm2708/bcm2708-pcm.c b/sound/soc/bcm2708/bcm2708-pcm.c
> > new file mode 100644
> > index 0000000..4b3e688
> > --- /dev/null
> > +++ b/sound/soc/bcm2708/bcm2708-pcm.c
> > @@ -0,0 +1,303 @@
>
> I think you should be able to remove the bulk of this driver by using the
> generic PCM dmaengine driver.


As implied in the header of this file, I would really like to use the
generic PCM dmaengine driver,
but I would also like to maintain compatibility to the Raspberry Pi
downstream kernel.
Therefore, I have to wait until the downstream kernel migrates to the
new version.



> [...]
> > +
> > +#include "bcm2708-pcm.h"
> > +
> > +static const struct snd_pcm_hardware bcm2708_pcm_hardware = {
> > +     .info                   = SNDRV_PCM_INFO_MMAP |
> > +                               SNDRV_PCM_INFO_MMAP_VALID |
> > +                               SNDRV_PCM_INFO_INTERLEAVED |
> > +                               SNDRV_PCM_INFO_PAUSE |
> > +                               SNDRV_PCM_INFO_RESUME |
> > +                               SNDRV_PCM_INFO_JOINT_DUPLEX |
> > +                               SNDRV_PCM_INFO_NO_PERIOD_WAKEUP,
>
> I don't think you actually support the last one, and neither pause and
> resume are supported.

I will have a closer look at these flags. Thanks!