[PATCH] ARM: ux500: Only configure wake-up reasons on ux500 based platforms

[Lee Jones]

On Fri, 24 May 2013, Linus Walleij wrote:

> On Thu, May 16, 2013 at 1:15 PM, Lee Jones <lee.jones at linaro.org> wrote:
> 
> > Multiplatform calls all enabled platforms' initcalls. In the
> > ux500_idle_init() initcall we call into the DBx500-PRCMU which in turn
> > executes some ux500 specific register reads/writes. When running on
> > some !ux500 platforms this ends up causing a kernel Oops. This patch
> > ensures the PRCMU call is only invoked when running on ux500 based
> > platforms.
> >
> > Reported-by: Rob Herring <rob.herring at calxeda.com>
> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
> 
> Patch applied for ux500 fixes.
> 
> Hm, again and again I get so confused by this, don't you say
> "wakeup CAUSE" rather than "wakeup REASON"?
> 
> Maybe I don't know the anglo saxon well enough...

The words 'cause' and 'reason' are fairly synonymous and are
interchangeable in a great many situations. You have to be an English
literary Nazi to care enough to work out the semantics, which in case
you hadn't noticed, I'm not. :)

But, credit where credit's due, in this particular instance you are
correct. Feel free to fixup.

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog