[PATCH] arm: omap: board-overo: reset GPIO for SMSC911x

[Florian Vaussard]

The reset GPIO should be set for the SMSC911x, otherwise the controller
will not work and probing will fail. In the case of the tobi-duo
expansion board, the second controller shares the same GPIO, thus no
more changes are required (not tested).

Signed-off-by: Florian Vaussard <florian.vaussard at epfl.ch>
---
 arch/arm/mach-omap2/board-overo.c |    3 ++-
 1 files changed, 2 insertions(+), 1 deletions(-)

diff --git a/arch/arm/mach-omap2/board-overo.c b/arch/arm/mach-omap2/board-overo.c
index 4ca6b68..5748b5d 100644
--- a/arch/arm/mach-omap2/board-overo.c
+++ b/arch/arm/mach-omap2/board-overo.c
@@ -68,6 +68,7 @@
 
 #define OVERO_SMSC911X_CS      5
 #define OVERO_SMSC911X_GPIO    176
+#define OVERO_SMSC911X_NRESET  64
 #define OVERO_SMSC911X2_CS     4
 #define OVERO_SMSC911X2_GPIO   65
 
@@ -122,7 +123,7 @@ static struct omap_smsc911x_platform_data smsc911x_cfg = {
 	.id		= 0,
 	.cs             = OVERO_SMSC911X_CS,
 	.gpio_irq       = OVERO_SMSC911X_GPIO,
-	.gpio_reset     = -EINVAL,
+	.gpio_reset     = OVERO_SMSC911X_NRESET,
 	.flags		= SMSC911X_USE_32BIT,
 };
 
-- 
1.7.5.4