[PATCH 01/39] dmaengine: ste_dma40: Separate Logical Global Interrupt Mask (GIM) unmasking

[Vinod Koul]

On Wed, May 15, 2013 at 06:29:51PM +0200, Linus Walleij wrote:
> On Wed, May 15, 2013 at 11:51 AM, Lee Jones <lee.jones at linaro.org> wrote:
> 
> > During the initial setup of a logical channel, it is necessary to unmask
> > the GIM in order to receive generated terminal count and error interrupts.
> > We're separating out this required code so it will be possible to move
> > the remaining code in d40_phy_cfg(), which is mostly runtime configuration
> > into the runtime_config() routine.
> >
> > Cc: Vinod Koul <vinod.koul at intel.com>
> > Cc: Dan Williams <djbw at fb.com>
> > Cc: Per Forlin <per.forlin at stericsson.com>
> > Cc: Rabin Vincent <rabin at rab.in>
> > Acked-by: Arnd Bergmann <arnd at arndb.de>
> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
> 
> Tentatively applied to my ux500-dma40 branch.
> 
> This lacks an ACK from Vinod...
Acked-by: Vinod Koul <vinod.koul at intel.com>
> 
> I cannot get any of this stack of patches up to ARM SoC
> before I have Vinod's ACK on all hitting drivers/dma/*
Wip ... :)

> 
> Yours,
> Linus Walleij