[PATCH 5/5] mmc: dw_mmc: Add support DW SD/MMC driver on SOCFPGA

[Dinh Nguyen]

Hi Arnd,

On 05/15/2013 12:11 PM, Arnd Bergmann wrote:
> On Wednesday 15 May 2013 11:40:12 Dinh Nguyen wrote:
>> On 05/15/2013 08:25 AM, Arnd Bergmann wrote:
>>> On Wednesday 15 May 2013, dinguyen at altera.com wrote:
>>>> +
>>>> +#define SYSMGR_SDMMCGRP_CTRL_OFFSET         0x108
>>>> +#define DRV_CLK_PHASE_SHIFT_SEL_MASK        0x7
>>>> +#define SYSMGR_SDMMC_CTRL_SET(smplsel, drvsel)              \
>>>> +    ((((drvsel) << 0) & 0x7) | (((smplsel) << 3) & 0x38))
>>>> +
>>>> +extern void __iomem *sys_manager_base_addr;
>>>
>>> This is not acceptable, you cannot just reference external symbols
>>> from one driver in another, without a proper interface.
>>>
>>> Please explain what the functionality is that you need here, then
>>> we can help you find the proper interface. My guess is that you
>>> need either the functionality provided by drivers/reset/
>>> or drivers/mfd/syscon.c.
>>
>> Our implementation has the timing controls for the SD/MMC controller in
>> another custom IP block(system manager). sys_manager_base_addr was
>> mapped in mach-socfpga/socfpga.c. I saw the same approach with
>> drivers/clk(clk_mgr_base_addr), so I thought it would be ok with this
>> driver. Please advise on another way to do this...
> 
> The clock code is tied more more closely to the platform code, so I
> was turning a blind eye on that one, under the assumption that it
> was only used there.

I think I can use the syscon interface for this. Thanks for the pointer.
I kinda thought that these dw_mmc-<platform> is platform specific
enough, but I will go the syscon route.

Dinh
> 
> 	Arnd
>