[PATCH 14/39] ARM: ux500: Stop passing Hash DMA channel config information though pdata

[Lee Jones]

DMA channel configuration information should be setup in the driver.
The Ux500 Hash driver now does this, so there's no need to send it
though here too.

Acked-by: Arnd Bergmann <arnd at arndb.de>
Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 arch/arm/mach-ux500/board-mop500.c |    4 ----
 1 file changed, 4 deletions(-)

diff --git a/arch/arm/mach-ux500/board-mop500.c b/arch/arm/mach-ux500/board-mop500.c
index 52ffe1c..ec916ca 100644
--- a/arch/arm/mach-ux500/board-mop500.c
+++ b/arch/arm/mach-ux500/board-mop500.c
@@ -446,11 +446,7 @@ static struct cryp_platform_data u8500_cryp1_platform_data = {
 static struct stedma40_chan_cfg u8500_hash_dma_cfg_tx = {
 		.dir = STEDMA40_MEM_TO_PERIPH,
 		.dev_type = DB8500_DMA_DEV50_HAC1_TX,
-		.src_info.data_width = STEDMA40_WORD_WIDTH,
-		.dst_info.data_width = STEDMA40_WORD_WIDTH,
 		.mode = STEDMA40_MODE_LOGICAL,
-		.src_info.psize = STEDMA40_PSIZE_LOG_16,
-		.dst_info.psize = STEDMA40_PSIZE_LOG_16,
 };
 
 static struct hash_platform_data u8500_hash1_platform_data = {
-- 
1.7.10.4