[PATCHv6 0/3] Add support for velocity network driver on platform devices
Tony Prisk
linux at prisktech.co.nz
Mon May 13 01:47:07 EDT 2013
v6 changes:
Remove more bus specific code from velocity_probe()
Make velocity_(suspend/resume) accept a struct device *
Simplify PM code to use velocity_(suspend/resume) - remove the individual
pci and platform functions.
Add a struct pci_dev variable to velocity_get_pci_info() to reduce churn
v5 changes:
Remove velocity_info union. Change velocity_info->pdev back to struct pci_dev.
Remove more 'if (pci)' sections.
Remove 'void *pdev' function parameters.
Pass correct variable to velocity_choose_state()
v4 changes:
Code tidyup as requested by Francois Romieu
Removed '#ifdef PCI' around PCI code. Compile tested on (!)PCI and (!)PM.
v3 changes:
Rebased against net-next.
Fix errors in pm code.
v2 changes:
Drop patch #1 as requested by David Miller.
Correct the PHYID_ICPLUS_IP101A MII bits - should be ON, rather than OFF.
Read the platform rev_id from the correct register [regs->rev_id]. It's possible
this would work for the PCI version as well and would remove the need for the
'if (pci)' test to set vptr->rev_id.
v1:
The first three patches are general tidyup.
[DROPPED] Patch ## just alphabetizes the #includes to make it easier to read.
Patch #1 replaces vptr->dev with vptr->netdev, in preparation of adding a
struct device *dev in Patch #3
Patch #2 replaces the pci dma functions with the generic versions.
I have build tested these patches but don't have a PCI velocity to run-test it.
I can't see that they should introduce any problems as it is all renames and
function swapping.
Patch #3 adds support for the velocity driver on devicetree platform devices.
Binding document included. This patch is compile-tested for PCI, and boot
tested on a VIA APC8750.
I think it would be pertinent to get some tested-by's for PCI users.
Regards
Tony Prisk
Tony Prisk (3):
net: velocity: Rename vptr->dev to vptr->netdev
net: velocity: Convert to generic dma functions
net: velocity: Add platform device support to VIA velocity driver
.../devicetree/bindings/net/via-velocity.txt | 20 +
drivers/net/ethernet/via/Kconfig | 3 +-
drivers/net/ethernet/via/via-velocity.c | 497 +++++++++++++-------
drivers/net/ethernet/via/via-velocity.h | 35 +-
4 files changed, 377 insertions(+), 178 deletions(-)
create mode 100644 Documentation/devicetree/bindings/net/via-velocity.txt
--
1.7.9.5
More information about the linux-arm-kernel
mailing list